Lanier R/C S.E.5A User Manual - Decal Locations
15
Study the kit box label for decal location.
1.
Using glass cleaner and a soft cloth, clean the
model surface thoroughly before applying
decal's.
Cut the decal sheets apart in sections, as
needed.
Peel the backing off the decal and apply the
decal to the location desired.
Decal Locations
3.
Slip the cowl over the nose of the plane with
the paper strips on the outside of the cowl.
Transfer the holes to the cowl.
Screw the cowl in place with four #2 x 3/8”
screws.
4.
Using a canopy glue, glue the dummy engines
in place just behind cowl and just above the
mounting screws for the cowl and cabane
struts. The exhaust pipe does not get glued
down past the cabane strut.
Cockpit
1.
Install the cockpit combing around the cockpit
and glue in place.
2.
Glue the headrest to the top of the turtledeck
and use masking tape to hold in place till the
glue dries.
Battery Location
1.
The battery will fit into the compartment on the
bottom of the nose of the plane
2.
We used the Electrifly 1500 mah 3 cell Li-Poly
battery.