Lanpro LP-355IR Installation Manual - page 3
of
7
www.lanpro.com
Active Products - Cameras - LP-355ir
Connect the camera to the hub or switch, also connect the
computer from where you will configure the camera.
Go to the network card “properties” and change it’s address
to this one: 192.168.1.1 subnet 255.255.255.0 as shown
in figure 6
1
2
Figure 6
B.- Camera configuration and setup:
B
Open your preferred browser as shown in figure 7 and go to the following address: 192.168.1.126
3
Figure 7
3