Lanta Quasar Micro Buster 2 Owner's Handbook Manual - Operating Modes
© Lanta Lighting™ 2010. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
Revision 1
Owner Handbook Quasar Micro Buster 2™
Operating Modes
Three distinct operating modes are supported by the unit. These allow the user to vary
the speed, flash frequency and control inputs of the Laser Effect generated. The pattern
displayed is a very wide angle of ±45° to either side of the front of the unit. Controls are
located on the rear of the unit.
1- Auto Run Mode
A permanently-on Red & Green starfield Laser Effect is generated by the unit. Sound
inputs are ignored by Auto Run mode.
Setting Run Speed
Use the “Master Speed” dial to vary the run speed of the Laser Effect. Rotate the dial fully
anti-clockwise for a static display.
2- Flash Mode
A Red & Green starfield Laser Effect is generated by the unit. This cuts into blackout and
back again based on control settings. Sound inputs are ignored by Flash Run mode.
Setting Run Speed
Use the “Master Speed” dial to vary the run speed of the Laser Effect. Rotate the dial fully
anti-clockwise for a static display.
Setting Flash Frequency
Use the “Auto Stroboflash” dial to vary the flash frequency of the Laser Effect.
3- Sound Activated Mode
A Red & Green starfield Laser Effect is generated by the unit. The unit responds to sounds
picked up by the in-built mic activating the Laser Effect based on control settings
Setting Run Speed
Use the “Master Speed” dial to vary the run speed of the Laser Effect. Rotate the dial fully
anti-clockwise for a static display.
Setting Sound Sensitivity
Use the “Voice Controller” dial to vary the sound sensitivity of the Laser Effect. Rotate the
dial anti-clockwise to reduce and clockwise to increase sensitivity.