Lantech CM-011A User Manual
Trademarks
Contents subject to revision without prior notice.
All trademarks remain the property of their respective
owners.
Copyright Statement
This publication may not be reproduced as a whole or in
part, in any way whatsoever unless prior consent has been
obtained from owner.
FCC Warning
The Fast Ethernet Switching Converter Series converters
have been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC
Rules. These standards are designed to provide
reasonable protection against harmful interference when
these devices are operated in a commercial environment.
These devices generate, use, and can radiate radio
frequency energy and may cause harmful interference to
radio communications unless installed in accordance with
this User’s Guide. Operation of these devices in a
residential area is likely to cause harmful interference
which will make the user responsible for the appropriate
remedial action at his / her own expense.
CE Mark Warning
These are Class A products. In a domestic environment
these products may cause radio interference in which case
the user will need to consider adequate preventative
methods.
1. Checklist
The Fast Ethernet Switching Converter package should
contain following items:
-
Fast Ethernet Switching Converter
-
AC-DC Power Adapter
Please notify your sales representative immediately if any
items are missing or damaged.
2. Overview
Fast Ethernet Switching Converter is designed to meet the
needs for massive optical fiber network deployment and able
to extend a legacy copper based network via fiber cable to a
maximum distance of up to 100KM.
Fast Ethernet Switching Converter is fully compliant with
IEEE 802.3 & 802.3u standards; built-in Switching ASIC has
turned Fast Ethernet Switching Converter to function more
like a 2-port switch than a traditional converter. Users can
get all switching benefits such as traffic segmentation,
frames checking & error filtering. In addition, LLF function
allows users to monitor & maintain their critical fiber link more
easily and effectively.
The installation & operation procedures of the Fast Ethernet
Switching Converter are simple & straightforward. Operation
status can be monitored through a set of Diagnostic LED
indicators on the front panel.
Major Features:
-
10/100Base-TX to 100Base-FX converter
-
Store & Forward Switching Mechanism
-
Comply with IEEE 802.3, 802.3u
-
MDI/MDIX Auto-Crossover supported
-
Auto-Negotiation or Manual mode setting of Speed &
Duplex mode
-
LLF
function
3. Installation
The installation procedure is simple and straightforward.
-
Attach fiber cable from the Fast Ethernet Switching
Converter to the fiber network.
-
Attach a UTP cable from the 10/100Base-TX network to
the RJ-45 port on the Fast Ethernet Switching
Converter.
-
Connect the power adapter to the Fast Ethernet
Switching Converter and check that the Power LED
lights up. The TX Link and FX Link LED will light when all
the cable connections are satisfactory.
100
LINK/
ACT
FX TX
FDX PWR
Fig. 1 Fast Ethernet Switching Converter Front
& Rear Panel
5VDC IN
1 0 / 1 0 0 B A S E - T X
N e t w o r k
S C / S T
F i b e r
N e t w o r k
T X
R X
R X
T X
F i g . 2
B a s i c N e t w o r k C o n n e c t i o n
1 0 / 1 0 0 B A S E - T X
TX RX
Quick Installation Guide
-