LanteScale MH-500 User Manual - II.
II.
TARE WEIGHING
1. Turn on scale as described above.
2. Place the ‘tare item” platform (the console).
3. Press [TARE] key, and wait until “0.0” is displayed.
4. Add the “net-weight-item”
III.
COUNTING FUNCTION
1. Turn on the scale and wait until the LCDdisplays“0.0”.
2. Place a sample amount (25pcs, 50pcs,75pcs or 100pcs)of
the quantity you wish to weigh and count onto the platform.
3. Press and HOLD [PCS] KEY FOR 2 Seconds; the LCD will
display a random number, for example“100”.
4. Press [UNITS] key to select the sample amount of the item
that you have put onto the platform.
5. Press [PCS] key to confirm the above information, the LCD
will now display “PCS” in the corner to show that the scale is
in counting mode.
6. Remove the sample quantity from the platform.
7. You now can place any amount of your item(s) on the scale
and the LCD will display a count.
8. You can switch between weighing mode and counting mode
by pressing [UNITS] or [PCS] key respectively.
IV
. Calibration:
1. Reset the scale by pressing [ON/OFF] key.
2. Wait until the LCD displays "0.00" and then press and
HOLD the [MODE] key for 3 seconds, the LCD will display
CAL" then release the [MODE] key.
3. Press the [MODE] key again, the LCD will display "CAL"
followed by the required calibration weight.