Lantronix 15.00.018 User manual - page 8
PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide
PC Fiberlynx User Guide Lightwave
Communications
Lightwave Communications
Lightwave Communications
Lightwave Communications
2-2
www.lightwavecom.com
Do not open the PCFiberlynx chassis; there are no user-serviceable parts inside.
2.1 Desktop
Use
Installation of the PCFiberlynx is simple and requires no special tools for desktop use. All
connections use industry-standard cabling and connectors. A ten foot long cable kit (P/N
200.0230) is included with the PCFiberlynx to connect the transmitter unit to the CPU. This
cable kit includes: one male-to-male HD15 (VGA) video cable, two male-to-male 6 pin mini-DIN
keyboard and mouse cables, one male-to-female DB9 serial cable, and two 3.5 mm stereo
audio cables. Eight rubber feet are also included to use the PCFiberlynx on a desktop.
2.2 Rack
Mount
The PC Fiberlynx units may be rack-mounted in a conventional 19-inch equipment rack. If rack
mounting, the user must install the rack mounting brackets (provided in the box with the unit)
and properly secure the unit in their rack. The PC Fiberlynx mounts from the front flanges only
(no rear support is required) using screws from your rack's manufacturer. If rack mounting, the
rubber feet included with the PC Fiberlynx are not required.
2:Installation
Rack Mount Bracket
Secures with 2 screws
Brackets are same on both sides
Remove these two screws
Place screws through holes in
Bracket and then retighten
Vent Louvers
Do Not Block