Lantronix XPress-DR Plus Quick Start Manual

Summary of XPress-DR Plus

  • Page 1

    2006 copyright © lantronix is a trademark of lantronix. All rights reserved. 900-428 rev. A 03/06 xpress-dr+ quick start guide xpress-dr+ industrial device server.

  • Page 2

    Xpress-dr+ quick start contents what’s in the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 pinou...

  • Page 3

    Q u i c k s t a r t g u i d e xpress-dr+ pinouts the xpress-dr+ supports rs-232 via rj45 connectors. It also supports rs-422/485 via screw terminals (serial port 2 only). Note: serial port 2 supports rs232, rs422, and rs485, but only one mode at a time. This means you can use either the rj45 connect...

  • Page 4

    4 w w w . L a n t r o n i x . C o m q u i c k s t a r t g u i d e xpress-dr+ 5 pinouts continued… pinouts continued note: termination resistors (r = 120 ohm) are used to match impedance of a node to the impedance of the transmission (tx) line.Termination resistors should be placed only at the extrem...

  • Page 5

    6 w w w . L a n t r o n i x . C o m q u i c k s t a r t g u i d e xpress-dr+ 7 quick connect continued typical installation quick connect warning: connecting a device to an active ethernet network can disrupt communications on the network. Make sure the device is configured for your application befo...

  • Page 6

    8 q u i c k s t a r t g u i d e xpress-dr+ w w w . L a n t r o n i x . C o m 9 assigning an ip address continued fixed ip address in most installations, a fixed ip address is desirable. The systems administrator generally provides the ip address, subnet mask, and gateway. The ip address must be with...

  • Page 7

    10 q u i c k s t a r t g u i d e xpress-dr+ w w w . L a n t r o n i x . C o m 11 deviceinstaller continued… 5. Enter the ip address. The subnet mask displays automatically based on the ip address; if desired, you may change it. On a local network, you can leave the default gateway blank (all zeros)....

  • Page 8

    12 leds contact for questions and technical support, please check our online knowledge base at www.Lantronix.Com/support lantronix 15353 barranca parkway, irvine, ca 92618, usa phone:(949) 453-3990 or fax: (949) 453-3995 www.Lantronix.Com w w w . L a n t r o n i x . C o m 13 q u i c k s t a r t g u ...