Vbd 1400 owner’s manual mobile audio system • pll synthesizer stereo radio • digital compact disc player • automatically memory storing • preset equalization • remote control • electronic detachable panel.
2 contents installation .....................................................................................................3 din front-mount (method a) ..................................................................................3 installing the unit .............................................
3 notes: • choose the mounting location where the unit will not interfere with the normal driving function of the driver. • before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • use only the parts...
4 removing the unit 1. Before removing the frame, press the (open/close) button to slide down the front panel. 2. Frame 3. Insert fingers into the groove in the right side of the frame and pull out to remove the frame. (you can also remove the frame from the left side.) 4. Lever after removing the f...
5 to reinstall the front panel 1. When the panel bracket is in slide down position, insert the front panel into panel bracket and press (open/close) button to slide up. 2. When the panel bracket is in slide up position, insert a side of the front panel to its proper position and push another side in...
6 green green/black grey grey/black violet violet/black main unit white white/black front lch speaker rear lch speaker front rch speaker rear rch speaker rch red lch white (grey) rear rca cable rch red lch white (brown) front rca cable antenna connector red yellow black choke box blue power antenna ...
7 location and function of controls operation general operation • on/off/illuminate switch on the unit by pressing any button (except (open/close) button (7) and eject button (24). When system is on, press ill/pwr button (9) shortly to adjust the brightness of vfd display, press it for several secon...
8 • remote sensor point the remote control handset to the remote sensor ir (23). Press the function keys on the handset to control the system. • reset reset button (25) is placed on the front panel and must be activated with either a ball point pen or thin metal object. The reset button is to be act...
9 if both buttons have not pressed for several seconds, they will retune to seek tuning mode and “auto” appeared on the display. • local/distance press loc button (2) shortly to select between local and distant stations. Local setting for reception of strong station, and a distant setting for recept...
10 remote control handset 8 6 2 1 3 4 5 7 14 9 13 11 12 15 10 control & function keys 1. Power = power on/off button 2. Mod = mode button 3. S = select button 4. Dsp = display button 5. Bnd = band select button 6. Ams = automatically memory storing & program scanning button 7. Vol + = volume up butt...
11 specification general power supply requirements : dc 12 volts, negative ground chassis dimensions : 178 (w) x 155 (d) x 50 (h) tone controls - bass (at 100 hz) : ± 10 db - treble (at 10 khz) : ± 10 db maximum output power : 4 x 60 watts current drain : 15 ampere (max.) cd player signal to noise r...
Trouble shooting before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom cause solution no power. The car ignition is not on. If the power supply is properly connected to the car accesso...
