Lanzar Vibe 440PSU Owner's Manual And Installation Manual

Summary of Vibe 440PSU

  • Page 2

    You are now own the vibe 440psu parametric equalizer, the product of an uncompromising design and engineering philosophy. Your vibe 440psu parametric equalizer will perform any other parametric equalizer in the world. To maximize the performance of your system, we recommend that you thoroughly acqua...

  • Page 3: Equalizer Background

    As in state-of-the-art home audio systems the optimum system requires a dedicated preamp with enormous gain to drive the various power amplifiers. Since home audio amplifiers do not have adjustable sensitivity, the require a high output preamplifier to drive them to maximum levels. This unit is the ...

  • Page 4: Controls (Front Panel)

    1. Preamp fader control: this control adjusts the volume between the front and rear output in 4-channel system. 2. Master voume control: this is the main control to adjust the output level. 3. Subwoofer volume control: this adjusts the level of the subwoofer output. 4. Subwoofer frequency control 5....

  • Page 5: Controls (Top Cover)

    4 11. Independently adjust the left and right channel input sensitivity for each input (source and auxilairy) turn the knob clockwise to increase the input level. Turn the knob counter clockwise to reduce the input level. Controls (top cover).

  • Page 6: Controls (Rear Panel)

    5 6 1.12v constant power lead (red): this is the main power input for the vibe 440psu and must be connected to a (+)12v constant power supply. Do not connect this to a switched 12v source or the system may pop when the key is turned off. 2.Remote turn-on input lead (blue): this is the input for turn...

  • Page 7: Installation Instructions

    1.Read this manual carefully and in its entirety before installing this equalizer. 2.Always disconnect the battery or remove the fuses for circuits you will be working on. 3.Check for clearance of any hazards such as wiring harnesses or heater core before mounting the equalizer to any panels in the ...

  • Page 8

    Initial settings 1.After completing unit installation, wire, and appropriate audio signal connections, power-up the source unit, play a familiar track, and set the volume level to approximately 75%. 2.Set all individual graphic equalizer controls to 0db. Master volume control and subwoofer level con...