1. DL manuals
  2. Lanzar
  3. Amplifier
  4. vibe4000D
  5. Owner's Manual

Lanzar vibe4000D Owner's Manual

Manual is about: Lanzar Class-D Mono Block

Summary of vibe4000D

  • Page 1

    A m e r i c a n c r a f t e d p e r f o r m a n c e vibe4000d owner’s manual class-d mono block.

  • Page 2

    V i b e r a n t o w n e r ’ s m a n u a l t a b l e o f c o n t e n t s table of contents feature and controls 1. Contents 2. Introduction 3. Features 4. Controls 5. Specifications 6. Amplifier installation 7. System wiring 11. Troubleshooting 1 -.

  • Page 3

    V i b e r a n t o w n e r ’ s m a n u a l - 2 thank you for purchasing the viberant class-d amplifier. Rest assured you have purchased a quality product designed and engineered to give you many years of uncompromised musical service. The viberant class-d amplifier has been designed using the latest ...

  • Page 4: F E A T U R E S

    3 - f e a t u r e s • 1 ohm stable mono block amplifier for subwoofer only. • mosfet power supply • pwm (pulse-width-modulation) system • glass epoxy pcb • gold plated rca inputs for line input & bypass output. • gold plated terminals for speaker output and power input. • thermal, overload and short...

  • Page 5: C O N T R O L S

    V i b e r a n t o w n e r ’ s m a n u a l - 4 c o n t r o l s class-d design low-frequency information for subwoofer only. High efficient power power supplies stiffly regulated pwm power supplies mosfet switches maintain rated power over a wide range of battery voltages. Crossover low pass filter ad...

  • Page 6

    V i b e r a n t o w n e r ’ s m a n u a l 5 - s p e c i f i c a t i o n s model vibe4000d rms at 4 ohms 375w mono rms at 2 ohms 650w mono rms at 1 ohms 900w mono at 4 ohms bridged 1200w mono at 2 ohms bridged 1800w mono min. Speaker impedance 1 ohm maximum power ouputs 2000w mono frequency response ...

  • Page 7

    V i b e r a n t o w n e r ’ s m a n u a l - 6 a m p l i f i e r a n d i n s t a l l a t i o n 1 find a suitable location in the vehicle to mount the amplifier 2 make sure there is sufficient air flow around the intended mounting location 3 bolt the amplifier to the mounting surface. 4 connect the po...

  • Page 8

    V i b e r a n t o w n e r ’ s m a n u a l 7 - front rear speaker output connection subwoofer s y s t e m w i r i n g signal input and bypass output connection head unit l/r audio outputs remote bass boost from mono singnal source to satellite amplifier line-input mode switch in off position speaker ...

  • Page 9

    V i b e r a n t o w n e r ’ s m a n u a l - 8 two monoblock amplifiers bridged for super-high power minimun impedance 2 ohms! Head unit l/r audio outputs remote bass boost from mono singnal source to satellite amplifier line-input mode switch in off position mode switch in on position amp a front am...

  • Page 10

    V i b e r a n t o w n e r ’ s m a n u a l 9 - two monoblock amplifiers bridged for super-high power this application makes amplifier a the master amplifier and amplifier b the slave amplifier. The master amplifier handles all the processing and level control adjustments, and its line output feeds an...

  • Page 11

    V i b e r a n t o w n e r ’ s m a n u a l - 1 0 s y s t e m w i r i n g power input connection to remote output from head unit to battery.

  • Page 12

    V i b e r a n t o w n e r ’ s m a n u a l 1 1 - t r o u b l e s h o o t i n g before removing your amplifier, refer to the list below and follow the suggested procedures. Always test the speaker and their wires first. A m p l i f i e r w i l l n o t p o w e r u p. Check for good ground connection. C...

  • Page 13

    V i b e r a n t o w n e r ’ s m a n u a l - 1 2.

  • Page 14

    Lanzar audio inc. 1600 63rd street, brooklyn, ny 11204 (718) 236-8000 www.Lanzar.Com.