Lanzar VIBEX2 User Manual - Functions

3

9. HIGH PASS GAIN CONTROL

For adjusting the channel output signal level.

10. SUBWOOFER STEREO/MONO SWITCH

For selection of stereo or mono mode subwoofer output.

11. HIGH-PASS FREQUENCY SELECTOR

For selection of high-pass crossover frequency between 80 Hz and 2.5KHz 

12. PHASE INVERTER 

Position the switch to the "180" position shifts the subwoofer output signals 180

degrees out-of-phase relative to the front and rear output signals.

13. BASS-BOOST LEVEL CONTROL (45Hz)

For increasing the Bass boost level up to +12dB.

14. LOW PASS SUBWOOFER FREQUENCY SELECTOR

For selection of the low-pass crossover frequency for the subwoofer channel

between 35 Hz and 400 Hz.

15. SUBWOOFER OUTPUT LEVEL REMOTE CONTROL TERMINAL.

To be connected to the remote control for exclusive maneuver of the subwoofer

output level, and the subwoofer output level control on the unit ("16" below) is by-

passed. 

16. LOW PASS SUBWOOFER OUTPUT GAIN CONTROL

For adjusting the subwoofer channel output signal level.

FUNCTIONS