Larsen & Brusgaard Viso II Manual

Manual is about: Digital Skydiving Altimeter

Summary of Viso II

  • Page 1

    Larsen & brusgaard mosevej 3 4070 kirke hyllinge, denmark phone: +45 4648 2480 fax: +45 4648 2490 e-mail: l-and-b@l-and-b.Dk viso ii manual 2 3 warning! Failure to follow all warnings, instructions, and required procedures may result in serious injury and death. Always ensure your altimeter is adjus...

  • Page 2

    6 7 4. Daily jump counter - displays number of jumps completed on last date and/or 9 other jump dates. Features • digital alti-meter or speed-meter • electroluminescent backlight for night jumping. Can remain on for several hours • automatic calibration to local elevation • lcd screen for easy and i...

  • Page 3

    12 13 main window this represents the starting point for all further actions and subsequent displays. Display the viso ii runs a self-test and displays all icons it then displays the firmware version number together with a factory reference number... ...And switches to a screen configuration referre...

  • Page 4

    18 19 the viso ii can be customised to your personal settings. Your settings will be stored and recalled also after replacing batteries. When you first get the viso ii, we recom- mend you to go through the setup selector to customise the viso ii settings. Setup selector in the setup area the followi...

  • Page 5

    24 25 explanation if the dz landing elevation differs from that of the aircraft take off elevation, offset the viso ii prior to entering the aircraft as follows: viso ii settings altitude offset press and hold or to offset the current altitude. Press to save setting and enter the dive type selector....

  • Page 6

    30 31 same body position), whereas tas will show a different speed throughout the dive (the same body position, different air density). Below are some recommendations and numbers for sas: a good base speed should be: 110-115 mph. A high base speed should be: 120-125 mph (tendency to wobble when dock...

  • Page 7

    36 37 turn viso ii off selector alti-meter/ speed-meter • feet/ meter when set to alti-meter • mph/ kmh when set to speed-meter • altitude offset • dive type • true airspeed (tas)/ skydiver’s airspeed (sas) • set current year • set current date • set current time • preset jump counter • reset jump c...

  • Page 8

    42 43 after landing the jump data can be displayed on the lcd by accessing the logbook area and profile area. Logbook area explanation: the logbook can store up to 200 jumps, and be reset at any time. It is not possible to delete a single jump. Perform access on to enter the logbook area (performing...

  • Page 9

    48 49 max. Speed under canopy jump number • exit altitude • deployment altitude • freefall time • max. Speed in freefall • max. Speed under canopy • padlock window max. Speed under canopy logbook area press or to scroll in max speed under canopy. Press to go to the padlock window. Max. Freefall spee...

  • Page 10

    54 55 important notice about speed recordings experience has shown that when mounting the viso ii on the hand or belly, different air pressures induced by hand or body movements may result in incorrect recordings of speeds. For more information about using the viso ii as a speed-meter, see page ?. P...

  • Page 11

    60 61 when the viso ii detects a fault, an error (“err”) symbol and trouble shooting numbers 2 to 5 and 100 are displayed in the upper part of the screen. At the same time the unit beeps every minute. The “err” trouble shooting codes are as follows: err 2 (transducer defective), err 3 (transducer ou...

  • Page 12

    66 67 other present altitude: +/- 10 ft (5 meters) operating altitude: 0 to 40,000 ft (0 to 12,191 m) clock: +/- 4 min/month operating temperature range: -30c to +60c (-22f to +140f) altitude offset range: - 9900 ft to +9900 ft -3000 meter to +3000 meter daily jump counter: max 10 dates battery type...