Larson Electronics DVR-ALG-4CH Quick Setup Manual
5
1
9
7
3
11
6
2
10
8
4
12
DVR-ALG Series 8CH back panel
5
1
9
7
3
11
6
2
10
8
4
12
DVR-ALG Series 16CH back panel
Item
Description
1
VIDEO IN
BNC connectors for camera video channels in. Number of channels is dependent on the model of the DVR.
2
Monitor Out (CVBS)
BNC connector for CVBS video monitor.
3
AUDIO IN
RCA connector for audio in cable.
4
ON / OFF switch
5
USB
6
HDMI
Connector HDMI monitor cable.
7
VGA
Connector VGA monitor cable.
8
AUDIO OUT
RCA connector for audio out cable.
9
LAN
RJ-45 connector for Ethernet drop cable.
10
RS-485 terminations
Connector for RS-485 devices. Connect the D+ and D- terminals to T+ and T- of PTZ receiver respectively.
11
12 Vdc
Plug for 12 Vdc power adapter.
12
GND terminal
Ground terminal post.
Mouse control
A standard 3-button (left / right / scroll-wheel) USB mouse can also be used with this DVR. To use a USB mouse:
1.
Plug the USB mouse into the either the front panel or back panel USB connector of the DVR.
2.
The mouse will be automatically detected. If the mouse is not detected, the mouse may not be compatible with the DVR. Please refer
to the recommended device list from your provider.
This guide provides instructions to initially setup the DVR-ALG series digital video recorder (DVR) for AHD, HD-TVI, 960H analog and IP
cameras.
DVR Front Panel
USB Interface
IR Receiver
Power LED
Status TX / RX
DVR-ALG Series front panel
Item
Usage
Power LED
Indicator turns green when DVR is powered up.
Status
STATUS indicator lights in red when HDD is reading / writing.
TX / RX
LED indicator blinks green when network connection is functioning properly.
IR Receiver
Sensor for the remote control.
USB Interface
DVR Back Panels
5
1
9
7
3
11
6
2
10
8
4
12
DVR-ALG Series 4CH back panel
DVR-ALG Series 4/8/16-Channel AHD, HD-TVI, 960H Analog and IP Camera Recorder Quick Setup Guide
1 of
4
www.larsonelectronics.com
Larson Electronics, LLC