Larson Electronics EXPRA-06R-LED User Manual
Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
EXPRA-06R-LED
WARNING:
To reduce the risk of explosion do not mix old batteries with used batteries from
different manufacturers.
To reduce the risk of ignition of a flammable or explosive atmosphere, batteries must be
changed only in a location that is known to be non-hazardous.
Do not charge Li Battery Pack in hazardous locations.
OPERATION:
Proper care of your new light is essential in order to get a long dependable life of service.
The battery pack provides 4 hours of continuous run time with a 5 hour charge.
NOTE:
In order to get the longest runtime out of your new flashlight, the unit must be fully
charged before its first use.
The rechargeable battery pack inside the right angle LED light is designed to be charged
inside the flashlight. Removing the Li-ion battery pack from the light is not necessary.
Simply slide the light down on the charger base until the light snaps in place. The light is
held firmly in place.
Once the flashlight is in the charging base, the charging indicator on the front of the
light will turn RED, indicating the unit is charging. In order to get the longest runtime out
of your LED light, leave the flashlight on the charger until the charging indicator turns
green.
Once the charging indicator has turned green, remove the light from the base by
pressing the latch behind the light and simultaneously pulling the light upward. Once
the light has moved upward approximately ¼”, the latch can be released and the light
can be safely removed.
A push-button switch on the side of the flashlight near the top turns the light on and off.
A belt clip and D-Ring allow for hands-free operation.
SAFETY:
Before using your light in a potentially hazardous location, please read the safety
approvals.
WARNING – Do not use any charger base or battery pack, other than the ones that are
shipped with the unit.