LARSON ESCAPE 800 Installation Instructions Manual - page 9
P A G E 9
J
L
B
B
N
P
N
P
L
LEFT
RIGHT
D
K
Q
B
F
4A
4B
6
4C
Windy conditions may affect the performance of a retractable screen. Retract the
screen in windy circumstances, during inclement weather, when not needed to
support immediate ventilation or during prolong periods when not used.
CHAIN LOCK
Position
H-Chain Lock on the side wall jamb so that it rests approximately 42"
up from the sill of the floor. Attach to the wall using
P - #8 x 1"(25mm)
Phillips Panhead Screws.
When the screen is fully extended and being used the Pull Chain should be oper-
ated so that the screen fabric is taut in the opening and then the chain should be
secured by the
H-Chain Lock. This will help retain the screen fabric in the B-Inside
Rails as wind hits the screen fabric.
CAUTION: Keep chain out of the reach of children at all times.
FOOT RELEASE LEVER
The
K-Foot Release Lever is an optional feature that makes it easier to slightly
rotate the
D-Pull Bar in order to disengage the L-Pull Bar Locks [Fig 4C] without
bending over. Before installing, position the
K-Foot Release Lever 12" to 20"
from the end of the
D-Pull Bar on the side closest to the Pull Chain. Attach the
K-Foot Release Lever to the D-Pull Bar using two Q - #6 x 3/8” (9mm) Phillips
Panhead Screws.
INSTALLING SIDE RAILS
Install the
L-Pull Bar Locks at the bottom of each B-Inside Rail. Be sure that the
L-Pull Bar Lock engages the D-Pull Bar as shown in image [Fig 4C]. Slide B-Inside
Rails onto the tabs protruding from the F and G-Cassette End Caps, with the
shorter pile to the inside [Fig 4D]. Use an 1/8” drill bit and first drill through both
sides of the
B-Inside Rails where they are to be fastened. Next, using a 3/8” bit,
drill through the outside face only. This will allow you to snap the
N-Screw Cover
Caps in place. Square and attach B-Inside Rails with P - #8 x 1”(25mm) Phillips
Panhead Screws. N-Screw Cover Caps.
Using the height adjustment wheel on the
L-Pull Bar Lock, adjust the height to
the appropriate level so that it easily engages the
D-Pull Bar. When correctly
adjusted the latching and unlatching should be smooth and easy.
Shorter Pile
4D
That’s it. Enjoy your new retractable screen!
ESCAPE 800 INSTALLATION INSTRUCTIONS
SURFACE INSTALLATION