LARSON EXP-EMG-EXT-42W SERIES Installation & Operation Manual

Page of 5

Download

Bookmark us

INSTALLATION, OPERATION &

MAINTENANCE DATA SHEET

(EXP-EMG-EXT-42W SERIES COMPACT FLUORESCENT EMERGENCY

FACTORY SEALED LIGHTING FIXTURES)

EXP-EMG-EXT-42W COMPACT FLUORESCENT

EMERGENCY FACTORY SEALED LIGHTING

FIXTURES

CAUTION:

death and property damage. Do not attempt installation until you are familiar with the following procedures. All

installation must comply with the applicable Electrical Code.

Make sure that the circuit is de-energized before starting installation or maintenance.

Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause

serious injury and or death.

Technical information, advice and recommendations contained in these documents is based upon information

that Larson Electronics believes to be reliable. All the information and advice contained in these documents is

intended for use only by persons having been trained and possessing the requisite skill and know-how and to

be used by such persons only at their own discretion and risk. The nature of these instructions is informative

only and does not cover all of the details, variations or combinations in which this equipment may be used, its

storage, delivery, installation, check out, safe operation and maintenance. Since conditions of use of the

product are outside of the care, custody and control of Larson Electronics, the purchaser should determine the

suitability of the product for his intended use, and assumes all risk and liability whatsoever in connection

therewith.

Page 1 of 5

Page 1
Installation, operation & maintenance data sheet (exp-emg-ext-42w series compact fluorescent emergency factory sealed lighting fixtures) exp-emg-ext-42w compact fluorescent emergency factory sealed lighting fixtures caution: death and property damage. Do not attempt installation until you are famili...
Page 2
1. Important safeguards – read and follow all safety instructions. E r o f e b d e l l a t s n i e b t s u m p m a l : e t o n operating remove globe assembly, unpack bulb and insert into socket. See installation instruction sections 4 & 5 for removal of globe assembly. Note: read this sheet careful...
Page 3
Following steps required for installation - 1. Install unit’s mounting accessory per instructions supplied with the mount. 2. Install unit’s pushbutton test station (purchased separately) per instructions supplied with the to provide a method of disconnection the supply source from the unit. An exam...
Page 4
3. Maintenance as routine maintenance, this emergency ensure it is working. The following schedule is recommended. 1. Visually inspect the charging indicator light monthly. It must be illuminated. 2. Test operation of the circuit at 30 day intervals for a minimum of 30 seconds. The lamp should opera...
Page 5
Save all instructions test & maintenance records unit location and/or number ________________________________________________________ date test duration maintenance performed comments 30 min. 1 ½ hr. Page 5 of 5.