LARSON RCL360-LED-80 User Manual - page 6
Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
Charging Remote Control
The remote control is equipped with a built-in lithium rechargeable battery. A USB charging cable is
included with each wireless remote control. When the remote control is on and the red indicator light
beneath the “Remote Control Power Switch” starts to blink, the built-in battery should be recharged.
Plug the charging cable into the “Remote Control Charging Socket” at the bottom of the remote
control. Connect the USB end into any USB power source such as a USB charger (not included) or a USB
power output from a computer (not included). A red indicator light near the bottom edge will come on.
This indicator light will become green when charging is complete. Unplug the USB cable. Charing the
remote control only when the red light starts to blink will extend the useful life of the rechargeable
battery. A rechargeable battery is usually good for about 1,000 charges.
Power ON/OFF Remote
While the remote control is off, press and hold “Remote Control Power Switch” until a green indicator
light comes on. Red lights under “Select 1
st
Group of Lights” and other function buttons will come on as
well. Remote control is ready to be used.
Change Light Intensity
The light has three brightness levels: High Intensity, Medium Intensity, Regular Intensity. Press
“Brighter +” button to increase the light intensity. Press “Dimmer –“ button to decrease the light
intensity or until the light is turned off.
Change Mode
Pressing the “Mode” button can cycle the light through three different modes: Steady, Strobe, and SOS.