Laser 5475 Manual

Page of 4

Download

Bookmark us

www.lasertools.co.uk

5475

Intelligent Battery Charger

4 in 1

Distributed by The Tool Connection Ltd

Kineton Road, Southam, Warwickshire CV47 0DR

T +44 (0) 1926 815000 F +44 (0) 1926 815888

info@toolconnection.co.uk

www.toolconnection.co.uk

If this product fails through faulty materials or workmanship, contact our

service department direct on:

+44 (0) 1926 818186. Normal wear and tear

are excluded as are consumable items and abuse.

Guarantee

Instructions

For all 12 volt automotive battery types: lead-acid, AGM (absorbed glass mat) Gel

and deep cycle.

This charger initiates an 8-stage charging cycle which charges and maintains

the battery. Additionally there is a boost mode for battery rescue, and a steady

12v supply mode. The charger can also be used to test the battery without

connecting to a 240v AC supply. It features overload, short circuit and polarity

reversal protection.

Includes a ‘snow’ mode for charging in temperatures below 0ºC

Note: this is for AGM absorbed glass mat batteries only - never attempt to charge

a battery with frozen electrolyte.

The charger is supplied with three methods of connection:

Insulated battery clamps.

Eyelet connectors for motorcycles.

Onboard 12v connector.

Page 1
Www.Lasertools.Co.Uk 5475 intelligent battery charger 4 in 1 distributed by the tool connection ltd kineton road, southam, warwickshire cv47 0dr t +44 (0) 1926 815000 f +44 (0) 1926 815888 info@toolconnection.Co.Uk www.Toolconnection.Co.Uk if this product fails through faulty materials or workmanshi...
Page 2
1. Soft start: tests if the battery can accept charge; charging will commence if battery is okay. 2. Desulphation: pulsing current removes sulphates from the battery plates and restores battery efficiency and capacity. 3. Bulk charge: charges with maximum set current until approximately 80% of capac...
Page 3
6 3 1. Identify the polarity of the battery terminals (if not clearly indicated, the positive terminal or post is normally larger than the negative). 2. Connect the positive (red) clamp to the positive battery terminal first. Some modern cars have a remote positive terminal located away from the bat...
Page 4
4 5 connect charger to battery as described in this instruction manual. Normal charger mode: • select this mode with the ‘charger mode’ button. Normal mode led will illuminate. • select desired charging current (rate) with the ‘charger current’ button. Led will illuminate indicating 2a, 5a or 10a. •...