Laser Rapier II Operator's Instruction Manual

Summary of Rapier II

  • Page 1

    Most important- when returning unit for service 1. All units returned under warranty must be accompanied by copy of original dated invoice. Failure to do this will incure repair charges. 2. Please include full details of the fault. 3. Include payment of £8 for return carriage. 4. Send unit to: servi...

  • Page 2

    What does the factory include with my detector? See unpacking the box on page 6. How do i put my detector together? See assembling your detector on pages 8-9. How do i install a new battery? See installing the battery on page 7. Is my battery working and when should i change it? See performing the a...

  • Page 3

    Laser rapier ii operator instruction manual congratulations! Thank you for purchasing the laser rapier ii. The rapier ii was designed for the user who requires top of the line performance com- bined with total ease of use. The laser rapier ii has the power and stability to handle the most hostile te...

  • Page 4

    Laser rapier ii operator instruction manual ☑ the searchcoil cable is hard wired to the searcoil and protected by a strain relief. Inspect the strain relief frequently to make sure it is firmly attached and intact. ☑ keep cables properly wound around the pole stems and protect them during use. Flopp...

  • Page 5

    Laser rapier ii operator instruction manual 3 field use ........................................................17 handling your detector..........................................................17 planting a test garden...........................................................18 recognizing false ...

  • Page 6

    Laser rapier ii operator instruction manual to be successful in treasure hunting with a detector you must: ♦ use a high-performance metal detector designed for the type of treasure hunting you will be doing. ♦ learn how to use your metal detector properly. ♦ search where there is buried treasure to ...

  • Page 7

    Laser rapier ii operator instruction manual the rapier ii is an ultra-lightweight, compact detector that packs the power and performance of a full-sized, heavier detector. By simplifying features and complicated adjustments that cause a loss of performance when used improperly, laser has created an ...

  • Page 8

    Laser rapier ii operator instruction manual pinpoint mode and check the target response sound. If the response is weak, it may well be a deep, good target. But if the response is very strong, it is probably trash. Note that a coin close to the surface can give a double beep sound, but it is regular ...

  • Page 9

    Laser rapier ii operator instruction manual your rapier ii is equipped with an automatic battery test circuit so that you can always be sure you are getting top performance. The battery should be checked after the detector has been on for about 10 minutes, and then periodically when used for long du...

  • Page 10

    Laser rapier ii operator instruction manual performing the audio battery test your rapier ii is equipped with an automatic battery test circuit so that you can always be sure you are getting top performance from it. The battery should be checked after the detector has been on for about 10 minutes an...

  • Page 11

    Laser rapier ii operator instruction manual 6) slide lower pole into middle pole until spring buttons click into the first set of adjustment holes. Turn pole lock to tighten-lock the as- sembly into place. 7) wrap the cable around the pole leaving enough slack near the searchcoil to permit searchcoi...

  • Page 12

    Laser rapier ii operator instruction manual setting the sensitivity level in maxboost the maxboost feature is a high gain boost over and above the normal maximum of 10 and is indicated by the red area on the sensi- tivity control. Using maxboost will cause no harm to your detector, but in certain co...

  • Page 13

    Laser rapier ii operator instruction manual 11 the rapier ii has only five controls, all mounted on the front panel of the housing for fingertip adjustment. How these controls should be set for peak performance will depend on the type of metal you are searching for, search site conditions, and so fo...

  • Page 14

    Laser rapier ii operator instruction manual may also need to change tone based on field condition, such as traffic noise, wind noise, flow water, ect. Threshold threshold level control this rotary control has one function: adjusts the threshold control the threshold control is used to adjust the aud...