LaserLiner SuperCross SCL 2 Operating Instructions Manual - English
ENGLISH
9
SuperCross-Laser SCL 2
Technical Data
Automatic levelling range
+ 4,5°
Accuracy
+ 5 mm / 10 m
Operating range (depending on room illumination)
20 m
Laser wavelength
635 nm
Laser class
2M /
Power supply
3 x1,5V AA / ca. 60 h
Weight
0,5 kg
Operating temperature
0°C ... +50°C
Storage temperature
-10°C ... + 70°C
Order number
081.120A
Subject to technical changes without notice
12/2006
Horizontal and vertical levelling:
Open the battery compartment (2) and insert batteries according to the symbols. Be sure to pay
attention to polarity. Release the transport restraint, put the ON/OFF switch (4) into its "ON" positi-
on. The cross laser will appear. The desired laser lines can be selected with the selection button (5).
Refer to Figures A, B and C on page 2 for application examples.
Slope mode:
Do not release the transport restraint, put the ON/OFF switch into its "OFF" position. Select and
switch on the laser with the selection button (5). Now slopes can be laid out. Refer to the applicati-
on example in Figure D on page 2.
IMPORTANT:
This mode cannot be used to perform horizontal
or vertical levelling because the laser lines are no longer automatically aligned.
Important:
The tilt function must be activated to perform horizontal and vertical levelling. Activate
this by releasing the transport restraint, put the ON/OFF switch (4) into its "ON" position. The tilt func-
tion will produce an alarm when the unit is outside its automatic levelling range of 4.5°. The alarm sig-
nal is audible and the lasers will shut off. When this happens, place the unit on a more even surface.
Note:
Regularly check the calibration before use, after transport and after extended periods of
storage.
Laserliner
Innovation in Tools
®
Anleit_SCL-2_Rev1206_NEU.qxp 08.12.2006 14:13 Seite 9