1. DL manuals
  2. Lassco Wizer
  3. Power Tool
  4. CR-60 Cornerounder
  5. User Manual

Lassco Wizer CR-60 Cornerounder User Manual

Summary of CR-60 Cornerounder

  • Page 1

    Before operating this equipment, please read these instructions completely and keep these operating instructions for future reference. Serial number: date of purchase: dealer: address: telephone number: cr- 60 cornerounder 485 hague street, rochester, ny 14606 u.S.A. Tel: 585-436-1934 fax: 585-464-8...

  • Page 2

    Introduction shipping damage inspection introduction page 01 thank you for your purchase of the cr-60 cornerounder . We ask that you take a moment to fill in the serial number and other information on the front cover of this manual. Please keep this manual as a reference for future use. Only the tab...

  • Page 3

    Page 02 all operators must read and understand the users manual and all other safety instruc- tions before using this equipment. Failure to fully understand the safety instructions can result in personal injury. If after reading the manual you are still uncertain about use, please contact the dealer...

  • Page 4

    Insert the press handle into the hub of the press and tighten the setscrew onto the press handle with a m4 hex key until the press handle is secure. Attaching the press handle setting up your machine page 03 press handle m4 hex key hub.

  • Page 5

    To put a radius on the corner of your product: with the press handle in the up position as shown, slide the product to be cut along the guide until it comes to rest against the inside edge of the outer knife. Hold the product in place firmly with one hand. Make sure to keep fingers away from the kni...

  • Page 6

    To remove the table assembly... Rotate the press handle to its full upright position so that the chrome knob is disengaged from the rack support plate. Using a 5/8” wrench (not provided) loosen, but do not remove the 7/16”-20 x 1” hex head table mount bolt. Remove the table assembly from the wooden ...

  • Page 7

    It is important to keep the outer knife in proper alignment or it can be pressed down at an incorrect angle causing unneces- sary stress on the knife. This can cause the outer knife to dull quicker and/or break. Remove the table assembly from the cr-60 arbor press before adjusting the outer knife (s...

  • Page 8

    Trouble shooting guide page 07 problem cause correction outer knife is out of adjusment. Adjust per the maintenance portion of this manual. Debris is wedged between the outer knife and the disk knife remove obstruction. The cams are adjusted too tight against the outer knife. Loosen the cam adjustme...

  • Page 9

    Parts diagrams page 08 cr-60 arbor press rack support plate (60-07) press handle (60-08) 7/16”-20 x 1” hex head table mount bolt 7/16” flat washer rack (60-06) wooden base (60-02) arbor press (60-01) rack shroud top (60-05) rack shroud (60-04a).

  • Page 10

    Parts diagrams page 09 table assembly front view top view rear view chrome knob chrome knob outer knife outer knife outer knife safety guard cam cam cam side guide side guide side guide disk knife disk knife welded wraparound welded wraparound table table table cam adjustment screw bottom mounting p...