Summary of 2000 – 4000 Series
Page 1
R 2000 - 4000 series user’s guide.
Page 2
Contents here’s all the information you need for setting and operating your new lathem time recorder. Service information is also included in this manual, in case any problems ever arise. Thank you for choosing a lathem time recorder. Should you ever need assistance, please let us know. Ordering acc...
Page 3
2000 – 4000 series time recorder user’s guide page 1 ordering accessories lathem time recorders fulfill a wide range of timekeeping requirements. For maximum results, only use lathem accessories specifically designed to fit your time recorder. To purchase the appropriate accessories for your time re...
Page 4
2000 – 4000 series time recorder user’s guide page 2 setting the time figure 1 determine your model before proceeding, it is important to know the exact model of your clock so it can be set properly. The fourth digit in the model number indicates the print format. Model print hours print units descr...
Page 5
2000 – 4000 series time recorder user’s guide page 3 raise the type section 1. Unlock the case cover and pull it forward to remove it. 2. Note the position of the release latch and face setting wheel used later in this process. 3. Wait until you hear the clock “click”. 4. Press either side of the ty...
Page 6
2000 – 4000 series time recorder user’s guide page 4 if your model prints tenths, (models with the 4 th digit of 2 or 5), go to the section “setting decimal wheel with tenths”. If your model prints hundredths or 00-23 hours, refer to the dial of decimal equivalents in figure 3 (page 5) to determine ...
Page 7
2000 – 4000 series time recorder user’s guide page 5 dial of decimal equivalents figure 3 the dial in figure 3 shows the tenths and hundredths setting for each minute. The inner circle represents regular minutes, the middle circle represents tenths, and the outer circle represents hundredths of a mi...
Page 8
2000 – 4000 series time recorder user’s guide page 6 setting decimal wheel with tenths figure 4 use only for recorders printing in tenths (models with a 4 th digit of “2” or “5”) 1 rotate tenths wheel (0.9)– figure 4, 4.1 until it is set at “9” rotate the main setting - figure 4, 4.3 until the tenth...
Page 9
2000 – 4000 series time recorder user’s guide page 7 set the time on the analog clock face figure 5 1. Make a sample registration on paper. 2. Rotate clock face setting wheel 5.1 until the clock face displays the same time as shown on the sample registration. Do not turn theclock hands except by usi...
Page 10
2000 – 4000 series time recorder user’s guide page 8 set the time on the digital clock face figure 6 1. Make a sample registration on paper. 2. Use the hour and minute buttons to set the display to the time shown on the sample registration. 3. To synchronize the display with the type wheels, listen ...
Page 11
2000 – 4000 series time recorder user’s guide page 9 changing the ribbon lathem time recorders have self-reversing ribbons. With normal use, a ribbon should last for many months or even years….And when the time comes, it is easy to change. Figure 7 1. Remove the top cover and raise type section (see...
Page 12
2000 – 4000 series time recorder user’s guide page 10 replacing the type section if your type section needs servicing, you can easily remove and replace it without sending the entire machine for service. Figure 8 1. Remove the top cover. 2. Remove type section retaining ring and washer– figure 8, 8....
Page 13
2000 – 4000 series time recorder user’s guide page 11 install / replace batteries in batt figure 9 the 2000-batt requires four “d” size batteries and should operate for six months before replacement. An internal beeper sounds momentarily each minute when the battery supply discharges below 4.5 volts...
Page 14
2000 – 4000 series time recorder user’s guide page 12 changing the motor figure 10 1. Unplug cord from wall outlet (except 2100batt). 2. Remove type section from main frame (see “replacing the type section”). 3. Figure 10 shows a close-up of cam block terminal. 4. Disconnect motor wire leads – figur...
Page 15
2000 – 4000 series time recorder user’s guide page 13 warranty one-year limited warranty lathem warrants the hardware products described in this guide against defects in material and workmanship for a period of one year from date of original purchase from lathem or from an authorized lathem reseller...
Page 16
Printed in usa p/n: omov0605a – revised 7-22-09.