Wireless digital wall clock model atddc4 installation & user’s guide.
This equipment complies with fcc requirements pursuant subpart j of part-15 this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includi...
Atddc4 series installation & user’s guide page 12 one year limited warranty lathem warrants the hardware products described in this guide against defects in material and workmanship for a period of one year from date of original purchase from lathem or from an authorized lathem reseller. The conditi...
Atddc4 series installation & user’s guide page 2 clock installation tools required for mounting the clock: • drill with a 5/16" bit • hammer • phillips head screwdriver • wall anchors • pencil separate the electronics from the enclosure and to set the time display format (12hr / 24hr). To do this, r...
Atddc4 series installation & user’s guide page 10 5. Slide the circuit boardassemblies in partially and secure the required wiring. 6. Slide the circuit board assemblies in fully, then slide the front lenses into place. Note: the inside of the lens has a paper backing which should not be removed. Th...
Atddc4 series installation & user’s guide page 4 mounting to a wall after deciding where to mount the clock, make two marks 12" apart and horizontal. Note: if mounting near a ceiling, make sure the holes are at least 2 1/4" away from the ceiling. Also, provide at least 16" of side clearance on one s...
Atddc4 series installation & user’s guide page 8 5. Slide the circuit board assemblies in partially and secure the required wiring. 6. Slide the circuit board assemblies in fully, then slide the front lenses into place. Note: the inside of the lens has a paper backing which should not be removed. Th...
Atddc4 series installation & user’s guide page 6 attaching conduit the electrical supply can be brought into the atddc4 enclosure from any of the top three vent-hole positions, from the back, or from either side. Conduit access is not available from the bottom. Note: optional plastic end-panels may ...
