Lava Computer Octopus-550 Installation Manual - page 2
of
8
Windows NT 4.0 Installation
1. With the power turned off, insert the Octopus-550 card into any free
PCI slot in your PC. Boot NT logging on as “Administrator”.
2. Place the
installation diskette into your floppy drive
and select Run from the Start Menu. When prompted type:
A:\NT4.0\Setup.
3. After the necessary files have been copied, select My Computer and
start Control Panel. A new icon will appear called “LavaPort.”This
applet should now be used to configure ALL Com Ports in your PC –
not just Lava serial ports.
Octopus-550
Please note that Com 1 may not appear in this applet if you have your
mouse attached to Com 1.