Lava Heat OPUS LITE Owner's Manual - page 13

12

OPERATION INSTRUCTIONS

Shut Down:

1. Turn control knob clockwise to PILOT. (Normally, burner will make a slight popping sound when 

extinguished.) Burner will extinguish but PILOT will remain ON.

2. To extinguish PILOT depress control knob and continue to turn it clockwise to OFF.

3. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.

Note: After use, some discoloration of the emitter screen is normal.

Operation Checklist

For a safe and pleasurable heating experience, perform this check before each use.

Before Operating:

1. I am familiar with entire owner’s manual and understand all precautions noted.

2. All components are properly assembled, intact and operable.

3. No alterations have been made.

4. All gas connections are secure and do not leak.

5. Wind velocity is below 10 mph.

6. Unit will operate at reduced efficiency below 40°F.

7. Heater is outdoors (outside any enclosure).

8. There is adequate fresh air ventilation.

When heater is ON:

The flame should be blue with straight yellow tops. If excessive yellow flame is detected, turn off 

heater and consult “Troubleshooting” on page 18.

Re-lighting:

Note: For your safety, control knob cannot be turned OFF without first 

depressing control knob in PILOT position and then rotating it to OFF. 

1. Turn control knob to OFF. 

2. Wait at least 5 minutes, to let gas dissipate, before attempting to relight Pilot, if do not wait at 

least 5 minutes, flash out will happen badly. 

3. Repeat the “Lighting” steps on prior page.

 WARNING

FOR YOUR SAFETY

Be careful when attempting to manually ignite this 

heater. Holding in the control knob for more than 20 

seconds before igniting the gas will cause a ball of 

flame upon ignition.

 WARNING

FOR YOUR SAFETY

Heater will be hot after use. Handle with extreme care.