Lava Heat Opus Owner's Manual - page 10
9
OPERATION INSTRUCTIONS
4. Press the DOWN button to switch to lower temperature setting and
UP button to switch to higher temperature setting.
TO TURN OFF THE HEATER
1. Press the POWER button.
2. Turn off the valve of the gas cylinder and disconnect the cylinder.
WARNING:
1. The whole gas system, hose, regulator, pilot or burner should be inspected for leak before use.
2. Check the hose assembly for sign of extreme abrasion, cuts or wears.Leak test suspected areas.
If there is evidence of excessive abrasion or wear, or if the hose is damaged or leaks, it must be
replaced with an Australian certified hose and regulator assembly.
3. Avoid twisting the flexible tubes and hoses.
4. Make sure the ventilation opening of the cylinder enclosure, control compartment, burner and
circulation air passageways of the heater are free and clear of debris.If debris, spider or insect
nests are found, clean the holes with heavy-duty pipe cleaner or compressed air.
5. Always keep a dry chemical fire extinguisher readily available.
6. For safety, always allow a 5-minute complete shut off period before re-lighting a hot heater.
7. Avoid repeated ignition attempts if ignition doesn’t start except for first time or new gas bottle starts.
Basic IR control
Battery type: 2 pcs AAA alkaline battery DC1.5v
If the appliance does not operate properly, switch off gas and refer to the problems
checklist at the rear of the manual. If the appliance can not be made to operate
correctly, contact your local gas supplier.
Temperature DOWN
Temperature UP
ON/OFF
POWER
Normal
Abnormal
Note:
In Normal condition,
the height of flame
is 2/3 height of glass
tube under Hi position.
the height of flame is
1/3 height of glass
tube under Low
position.The flame is
stable and bright.
No noise nor black
smoke.Contrarily it is
abnormal condition.