Lava Tr LG-112/4F Use And Care Instruction Manual
When using electrical appliances, especially when
children are present, basic safety precautions should
always be followed, including the following:
Read all instRuctions befoRe using.
KeeP aWaY fRoM WateR.
dangeR -As with most electrical appliances, electrical parts
are electrically live even when the switch is off.
to reduce the risk of death by electrical shock:
1. Always "unplug it" immediately after using.
2. Do not use while bathing.
3. Do not place or store appliance where it can fall
or be pulled into tub or sink.
4. Do not place in or drop into water or other liquid.
5. If an appliance falls into water, "unplug it" immediately
Do not reach into the water.
WaRning -to reduce the risk of burns, electrocution,
fire, or injury to persons:
1. An appliance should never be left unattended when
plugged in.
2. Close supervision is necessary when this
appliance is used by, on, or near children or individuals
with certain disabilities.
3. Use this appliance only for its intended use as described
in this manual.
do not use attachments not
recommended by the manufacturer.
4. Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped
or damaged in any manner or dropped into water.
Return the appliance to a service center for examination
and repair.
5. Keep the cord away from hot or heated surfaces.
do not wrap the cord around the appliance.
6. Never block the air openings of the appliance or place
it on a soft surface, such as a bed or couch, where the
air openings may be blocked. Keep the air openings free
of lint, hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any opening or hose.
9. do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is
being administered.
10. do not use an extension cord with this appliance.
11. This curling iron and clip are hot when in use.
To avoid burn hazard, do not let eyes and bare skin
touch heated surfaces.
iMPoRtant safetY
instRuctions
saVe tHese
instRuctions
oPeRating instRuctions
This appliance is intended for household use.
This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet
one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician.
do not attempt to defeat this safety feature.
iMPoRtant: This appliance is designed for optimum styling
results on all hair types; the plates will get extremely hot so use
extra caution.
NOTE: It is normal for this appliance to emit a slight odor and or
smoke during its initial use.
useR Maintenance instRuctions
Maintenance
Your appliance is virtually maintenance free. No lubrication is
needed. Keep heated surfaces clean and free of dust, dirt, and
hair spray. If cleaning becomes necessary, unplug the appliance
from the power source and wipe the exterior with a damp cloth.
If the cord becomes twisted, untwist prior to use.
WaRning: If any malfunction occurs, do not attempt to repair.
This appliance has no user-serviceable parts.
stoRage:
Allow appliance to cool before storing it away in a safe dry place
that is out of the reach of children. Never store it while still hot
or plugged into an outlet.
Never wrap the cord tightly around the unit.
do not hang the
appliance by the power cord and avoid pulling or straining
especially at the point where it enters the unit and at the
plug connection.
12. do not place the heated curling iron directly on any surface
while it is hot or still plugged in. Use the stand provided.
getting staRted
If necessary, attach the plates.
to attach:
1. Be sure unit is unplugged and plates are cool.
2. If the handle is locked, flip the lock/unlock switch
up to unlock.
3. Hold handle with one hand.
4. With the other hand, align side tabs on narrow end of plate
holder with corresponding notches in the handle. Slide plate
holder into the handle, push down gently and turn
clockwise until it locks securely in place.
5. Repeat above steps for the other plate.
basic stYling
Place the iron on a flat surface that is resistant to heat, plug into
an electrical outlet and slide On/Off switch left. Red indicator
light illuminates. This appliance will heat up quickly so be
careful when handling it.
Allow iron to heat for 2-3 minutes to reach the ideal
styling temperature.
For best results start with clean dry hair.
This iron offers four types of styling plates for a variety of styles.
• Crimpingandwavingplatesforaddingtextured
waves to hair
• Straighteningplateshelprelaxunrulycurlyhair
• Curvedplatesforsoftcurlsandwaves
1. To select a plate, press and rotate the button at the end
of the plate holder until you see the desired plate and the
button is released.
Note: If the button stays locked in, the plate is not
positioned correctly.
2. Repeat the same process for the other plate. Make sure
you choose the same type of plate.
3. To style, work with hair sections that are no more
than 2" wide and 1/2" thick.
iMPoRtant: Do not hold the product in one place
when in contat with hair for more than a few seconds.
Test a small section of your hair to determine your
particular styling time. Times will vary depending on
hair type, texture and condition.
4. using straight or curved plates:
Starting about 1/2" from scalp place hair between the hot
plates for a few seconds and pull through hair, maintaining
some tension.
For a finishing touch, turn iron under just a half turn when
nearing end of hair.
Release pressure from handle and allow hair to slip out.
5. using crimping or waving plates:
Starting about 1/2" from scalp place hair section between
the hot plates and press firmly for a few seconds. Release
pressure allowing hair to slip out. Move the appliance down
and repeat this process to achieve your desired look.
Do not crimp or wave over a previously styled section.
6. When finished, lock the handle. Bring the plates together
and press the lock/unlock switch down until the handle
is locked.
detacHing Plates:
The plates are detachable for easy storage.
1. Be sure unit is unplugged and plates are cool.
2. Flip the lock/unlock switch up to unlock the handle.
3. Hold iron with one hand and press the release button
on the handle.
4. With the other hand, turn the plate holder counterclockwise
and pull straight out.