1. DL manuals
  2. Lavry
  3. Amplifier
  4. Latency Killer LK-SOLO
  5. Owner's Manual

Lavry Latency Killer LK-SOLO Owner's Manual

Manual is about: HP Amp| 2x2 Loop Thru Mixer

Summary of Latency Killer LK-SOLO

  • Page 2

    With latency killer tm technology model lk-solo hp amp

  • Page 3

    Warning 3 warning table of contents warning ................................................................................................................................................... 3 introduction ................................................................................................

  • Page 4

    Table of contents 4 power switch ................................................................................................................................................ 8 ac power connector ........................................................................................................

  • Page 5

    Introduction 5 introduction the lavry latency killer – solo (lk-solo) is an extremely high-quality headphone amplifier capable of effortlessly driving a wide range of headphones from a stereo source, with precise and resettable control of the volume in half db steps. In addition, the lk-solo can pro...

  • Page 6

    The front panel 6 headphones with 1/8” mini plugs can be connected to this output using an adapter. Layout this section gives an overview of the controls and connectors of the lk-solo. More detailed information is available in later chapters of this manual. The lavry lk-solo has a simple user interf...

  • Page 7

    The front panel 7 ch1/m ono i nput this ¼” input receives ch1 when recording two channels. When nothing is connected to the ch2 input , ch1 is routed to both ch1 and ch2 of the headphone mix as a mono input. Ch2 i nput this ¼” input receives ch2 when recording two channels. S election i ndicator led...

  • Page 8

    The rear panel 8 figure 3- rear panel layout 9. Stereo input left 10. Stereo output left 11. Stereo input right 12. Stereo output right 13. Ch1 output 14. Ch2 output 15. Power switch 16. Ac power connector s tereo i nput l eft this ¼” input receives the left analog output of the daw or of any stereo...

  • Page 9

    Setup and use 9 setup and use this section assumes that you have read the layout section of the manual, and are familiar with the basic operation of the front panel controls as well as the input and output connections. This simple set-up allows the lk-solo to function as a headphone amplifier. 1. Co...

  • Page 10

    Setup and use 10 the lk-solo has two front panel inputs for recording source connection: ch1/mono and ch2 . The ch1/mono input can serve as a mono input when only one source is to be recorded. When there is nothing plugged into the front panel ch2 input, the signal is routed from the ch1/mono input ...

  • Page 11

    Setup and use 11 1. First, complete all steps listed in the section titled setup for playback listening included previously in this chapter of the manual. 2. Select ch1 and lower the volume to zero. 3. Select ch2 and lower the volume to zero. 4. Connect one live signal source to ch1/mono input . 5. ...

  • Page 12

    Recording with the lk-solo 12 recording with the lk-solo requires the same operational techniques used with “low latency” overdubbing systems. The performer will not monitor their “live” signal through the daw. The recording software input channels must be set to remain in “playback mode” and not sw...

  • Page 13

    Specifications 13 specifications the lk-solo inputs accept both “+4” professional line level and “-10” (consumer) line level signals. Inputs may be either balanced or unbalanced. With the exception of the headphone output, each of the outputs of the lk-solo is hard-wired to an input. As such, the ou...

  • Page 14

    Appendix 1 14 appendix 1 – connection diagram.

  • Page 15

    Warranty 15 limited warranty – lavry lk-solo subject to the conditions set forth below, for one year after the original purchase date of the product, lavry engineering will repair the product free of charge in the united states in the event of a defect in materials or workmanship. Lavry engineering ...