Lawn-Boy 10730 Operator's Manual - Charging The Battery
4.
Insert the dipstick into the oil-fill tube, but do not
screw it in.
5.
Remove the dipstick and read the oil level on the
dipstick (Figure 5).
•
If the oil level is low, add a small amount of oil
slowly to the oil-fill tube, and then repeat steps
3 through 5 until the oil level on the dipstick is
correct.
•
If the oil level is high, drain the excess oil until the
oil level on the dipstick is correct. To drain the
excess oil, refer to Changing the Engine Oil (page
13).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6.
Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil (page 13).
Charging the Battery
(Electric-start models only)
Refer to Charging the Battery (Electric-start models only)
(page 14).
Product Overview
12
Figure 6
Electric-start model shown
1.
Self-propel-drive bar
(self-propel models only)
7.
Ignition key (electric-start
models only)
2.
Recoil-start handle
8.
Battery (not shown;
electric-start models only)
3.
Grass bag
9.
Fuel-tank cap
4.
Oil fill/Dipstick
10.
Air filter
5.
Cutting-height lever (2)
11.
Spark plug
6.
Blade-control bar
12.
Battery charger
(electric-start models
only)
7