Lawn Genie Lawn Dial LD-4 Operator's Manual - page 5
Canceling
a
Program
Start Time
1. With the dial set to the START TIME position, use the + and -
buttons to set the start time to Off, (which is between the times
of
1159pm..
.OFF.. .12:00am.. .12:01 am..
.).
To accomplish
this, you can go forward or backward in time.
2. If a program has both start times turned off, then that program
is Off. (All other program details are retained). Because there
are no start times, there will be no watering with that program.
This is a convenient way to stop one program without turning
the dial to the OFF position. You may need the other program
to water.
Setting
Valve Run Times
Follow the steps below to program how long each valve will
water.
1.
Set the dial to the VALVE RUN T/ME position.
2. Select program A or B.
3. The display will flash the valve number A, the run time for that
4.
valve, and will show the program letter selected (A or B).
Use the + and - buttons to change the time shown on the
display. (Continuous pressure on the button, longer than 3
seconds, causes rapid change.)
5. Press
to advance to the next valve.
6.
Repeat steps 4 and 5 for each valve.
7. You may set valve run times from zero minutes to four hours.