Lawnbott spyder LB1200 Installation Manual

Summary of spyder LB1200

  • Page 1

    - - 1 i i n n s s t t a a l l l l a a t t i i o o n n c c o o u u r r s s e e l l a a w w n n m m o o w w e e r r r r o o b b o o t t introduction & features.................................................................................................................................. 2 start-up /...

  • Page 2: Introduction & Features

    - - 2 introduction & features remember that : maximum coverage 500 sq.M. However, it is a good idea to not exaggerate and bear in mind that gardens that are more complicated reduce the square meters covered by the robot. Maximum slope limit of 27° the robot can mow this maximum slope limit. Remember...

  • Page 3: Start-Up / Installation

    - - 3 start-up / installation getting started recharge the robot first, recharge the robot. It will come in handy at the end of installation for checking the correct functioning of the lawn mower. Fix the garden before starting the robot, the customer must be instructed on how to fix up the lawn. Th...

  • Page 4

    - - 4 the figure below shows a correct installation. Turning off the cutting blade. The robot turns off the cutting blade due to the following reasons - tall grass or slow motor speed. - a handle was touched. - the robot exceeded a 30° slope - the inclination of the robot has changed too quickly. - ...

  • Page 5: User Interface (Led)

    - - 5 user interface (led) the keyboard consists of only two keys, an on/off key and a key to start and stop the robot. The led always shows the status of the robot. The leds relating to the batteries show their charge level when the robot is running and when it is in pause. Two leds must be checked...

  • Page 6

    - - 6 when a robot stops, the first thing to understand is the condition of the “on” led and the “pause” led connections and upgrade - motherboard.