LAZBOY Refresh Owner's Manual - page 29
29
For HELP, call La-Z-Boy
®
Spas at 1.800.465.2933.
FILTER CYCLES
To program the filter cycles, you must enter the
duration of the cycle and frequency of the cycle.
During a filter cycle the pumps run for one minute
to purge the plumbing and then the filtration pump
runs for the remaining duration of the filter cycle.
SETTING THE TIME OF DAY
In order to set the time of day you must press and
hold the PROGRAM key for 5 seconds. The dis-
play will show the time of day with the hours flash-
ing. Use the temperature keys to change the
hours. A press of the PROGRAM key will then
flash the minutes. Once again use the tempera-
ture keys to change the minutes. A final press of
the PROGRAM key will program the time.
HEATER FUNCTION
In a regulation cycle, the system first generates
water flow through the heater housing and the
plumbing, in order to ensure accurate water tem-
perature readings as well as avoiding heater acti-
vation in dry conditions.
The system verifies periodically that all parame-
ters are within the normal range.
If the readings received from the system are not
valid, blanks (- - -) will be displayed until normal
readings have been successfully found.
After verifying pump activation and taking a water
temperature reading if required, the system auto-
matically turns the heater on to reach and main-
tain water temperature at the set point. The heater
indicator lights up when the heater is on, It flashes
when there is a request for more heat but the
heater has not started yet.
PUMP / JETS FUNCTION
Press this pad to activate the pump
1st press – turns on low speed (P1 only)
2nd press – turns on high speed (1st press P2)
3rd press – turns off (2nd press P2)
Pump 1 is a two speed pump and pump 2 is a sin-
gle speed pump that run on high speed only for
hydrotherapy. A built in timer automatically turns
the pumps off after 15 minutes unless it has been
manually deactivated. The pump indicator icons
turn on when each pump is activated.
PUMP AUTOMATIC TIME-OUT
High speed –
15 minutes
Low speed –
30 minutes
PROGRAMMING THE FILTER CYCLE
In order to program the filter cycle you must
press and hold the PROGRAM key for 5 seconds.
The display will show the time of day with the
hours flashing. A press of the PROGRAM key will
then flash the minutes. A press of the PROGRAM
key will display FS (filter start time). Use the tem-
perature UP and DN keys to select the start time.
A press of the PROGRAM key will display FD
(filter duration). Use the temperature UP and DN
keys to select the duration (0-24 hrs). A press of
the PROGRAM key will display FF (filter frequen-
cy). Use the temperature UP and DN keys to set
the frequency (1-2). A press of the PROGRAM
key will display EP (economy mode program-
ming). Use the temperature UP and DN keys to
turn off or on (0-1). A press of the PROGRAM key
will display ES (economy start). Use the tempera-
ture UP and DN keys to set the start time. A press
of the PROGRAM key will display ED (economy
duration). A press of the temperature UP and DN
keys will select the duration (1-24 hrs). A press of
the PROGRAM key will display a flashing F. Use
the temperature UP and DN keys to toggle be-
tween F and C. Press the PROGRAM key to exit
the programming.