LC-POWER LC-HEAD-1B User Manual - page 4
LC-HEAD-1B/W
5. How to use the Bluetooth function
5.1 Switching on / off the headphones manually
Function
Operation
LED indicator
Indication tone
Switch on
Press the MFB button for 3
seconds and release it, the
red LED is on
Red LED is on for 200
milliseconds, then blue
LED blinks and red LED is
off
Long tone
Switch off
Press the MFB button for 3
seconds and release it, the red
LED is on
Red LED is on for 200
milliseconds
Long tone
Note: In order to save power, the headset will automatically switch off if no device can be
connected within 5 minutes after switching on.
5.2 Pairing the headphones with a Bluetooth device
a) How to enter pairing mode:
Function
Operation
LED indicator
Indication
tone
Enter
pairing
mode
Make sure the headphones are turned off. Press and
hold the MFB button for 5 seconds and release it, the
red and blue LEDs blink alternately
Red and blue
LEDs blink
alternately
Long tone,
then two
short tones
b) Pairing the headset with a Bluetooth mobile phone
Please make sure your mobile phone has a Bluetooth function that can be used.
Specific pairing procedures may vary with different mobile phones. Please refer to your mobile
phone manual for further information. Usual connection steps as follows:
•
Please keep the headphones and mobile phone within the range of 1 meter when pairing.
•
Let the headphones enter into pairing mode (please refer to “Wireless connection and
pairing”).
•
Start the Bluetooth function of the mobile phone and search for Bluetooth devices. Then
select “LC-HEAD-1” in the Bluetooth device list.
•
According to indication, enter the password or PIN number ”0000” and press ”Yes” or
“Confirmed”.
•
After successful pairing, select “LC-HEAD-1” in the Bluetooth device list and press “connect”.
•
After successful connecting, the blue LED of the headphones quickly blinks twice every four
seconds.
Notes: If pairing is not successful, please switch off the headphones, turn them back on and re-pair
according to the steps mentioned above.
After pairing is successful, paired devices will remember each other. Unless pairing information is
deleted because of new pairing, there will be no need to pair them again when using next time. The
headphones can remember eight paired devices. When paired devices exceed the amount of 8, the
first one will be replaced.
4