LCD Concepts MEH-4P-F User Manual - Lcd Concepts, Inc.
3 |
P a g e
Installation of the MEH-4P-F Hub
This section will explain how to connect Ethernet devices to your MEH-4P-F hub and how to mount
the hub.
Mounting the Hub
The MEH-4P-F can be mounted in any orientation such as a flat surface, a wall or under a desktop
(see Precautions section of the manual). Four mounting holes are provided; two on each end of the
hub. Use four #6 screws for this purpose. Mak
e sure that there is at least 4” of clearance between all
connectors on the MEH-4P-F and the nearest surface or object to allow the Ethernet and power
cables to be plugged in. The added clearance will also facilitate troubleshooting.
Dimensions of hub:
Length-
8 3/8”, Width-6 1/4”, Height- 1 1/2”
Note: The length is measured from connector to connector
Connecting the Hub
PC to MEH-4P-F
Connect the hub to a computer using a cable supplied by or purchased from Furuno with a
Furuno connector on one end and a RJ-45 connector on the opposite end.
Suggested Furuno cables: 000-144-601, 0.5 Meters
MEH-4P-F to NavNet or Other Ethernet Devices
The MEH-4P-F can be connected to the NavNet using the cables provided or purchased.
Suggested Furuno cables: 000-154-027, 1 Meter
000-144-422, 5 Meters
000-154-050, 10 Meters
The MEH-4P-F can also be connected to other Ethernet devices using Furuno
cable/connectors and the appropriate RJ-45 adapter. The connection can be from any port on
the MEH-4P-F to any of the MDI-X, 10Mbps ports on another hub or other device.
LCD Concepts, Inc.
E-Mail:
Sales@LCDConcepts.com
www.LCDConcepts.com