1 led wall tri lcg-027a user manual please read the instructions carefully before use.
2 1. Safety instructions: • please keep this user manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • unpack and check carefully there is no transportation damage before using the fixture. • before operating, ensure that th...
3 3. Technicals specifications • led: 18 x 3w tri rgb • beam angle: 40° • black housing • dual yoke for floor mounting • led display • power in & out, dmx in & out • ip rate: ip65 • operations modes: built-in program / auto run / dmx / master slave / static colors • dmx-512: 1 / 3 / 4 / 4 / 6 channe...
4 “fsxx”, press the “up” or “down” to adjust the speed for the strobe fs00~fs99. C. When led display show pr.02-pr.1, first time press “setup”, it will show “sp.Xx”, then you can set up the speed for the program through pressing “up” or “down”, sp01~sp100(fl); second time to press the “setup”, it wi...
5 207-229 pale green 230-252 white 253-255 warm white dmx mode 2: 3channels ( 3c ) channel value function 1 0-255 red 2 0-255 green 3 0-255 blue dmx mode 3: 4 channels ( 4c-1 ) channel value function 1 0-255 master dimmer 2 0-255 red 3 0-255 green 4 0-255 blue dmx mode 4: 4 channels ( 4c-2 ) channel...
6 ch2 channel is 0-25) 36-44 r200 g255 45-53 r100 g255 54-62 r40 g255 63-71 g255 72-80 g255 b50 81-89 g255 b150 90-98 g255 b255 99-107 g150 b255 108-116 g50 b255 117-125 b255 126-134 r50 b255 135-143 r150 b250 144-152 r255 b255 153-161 r220 b50 162-170 r150 g50 b100 171-179 r50 g220 b100 180-188 r50...
7 ch6 104-129 pr05 (3 color status step) 130-155 pr06 (dream 1) 156-181 pr07 (dream 2) 182-207 pr08 (red gradual change) 208-233 pro9 (green gradual change) 234-255 pr10 (blue gradual change) 4. Master/slave mode press mode button, enter slave mode “slav” the effect program of the master light on bu...
8 termination reduces signal errors and to avoid signal transmission problems and interference. It is always advisable to connect a dmx terminal. (resistance 120ohm 1/4w ) between pin2 (dnx-) and pin3 (dmx+) of the last fixture. 1. Connect the fixture together in a “daisy chain” by xlr plug cable fr...
9 • no response to the sound: 1. Make sure the fixture does not receive dmx signal 2. Check microphone to see if it is good by tapping the microphone. • one of the channels is not working well: 1. The stepper motor might be damaged or the cable connected to the pcb is broken 2. The motor’s drive ic ...
