LCN 4310ME Series Installation Instructions
*18762*
18762
© Allegion 2014
Printed in U.S.A.
18762 Rev. 01/14-m
Door closer with electronic release & Multi-point hold open
4310ME Series
Installation Instructions
1
Closer Installation
1a Closer Information
Closer is handed at the factory. The hand of the closer must match
the hand of the door (see the door handing diagram below).
1b Voltage
Voltage supplied to the door frame MUST match voltage of the
solenoid.
1c Before beginning this step, determine which type of
wiring option will be used, and follow the
corresponding instructions:
Concealed Wiring:
see Figure 3 on page 3.
a. Prepare the frame per the
proper template on page
4. Be sure all the holes are
dimensioned correctly before
drilling and tapping.
b. Assemble the conduit
connector provided to the
flexible conduit, then attach to
the hole in the mounting plate.
c. Secure the mounting plate
to the frame with the screws
provided.
Surface Wiring:
see Figure 4 on
page 3.
L
NOTE: Remove the knockout in the top of the cover.
a. Prepare the frame per the proper template on page 4. Be sure
all the holes are dimensioned correctly before drilling and
tapping.
b. Secure the mounting plate to the frame with the screws
provided.
c. Attach the surface run
Z\x
” EMT conduit to the hole in the
bracket on the mounting plate. Be sure the conduit is securely
attached to the bracket.
1d Wiring Connections
Make the wiring connections at this time. Connect the two black
wires to the input voltage (polarity is not important). The green wire
MUST be connected to an earth ground (see Figures 3 & 4 on page
3).
1e Spacer/Arm
Place the spacer on the closer shaft, slide the arm onto the closer
shaft, and secure it with the arm shaft screw (see Figure 1 on page
3).
1f Track Roller
Insert the track roller into the track, and end caps into both ends of
the track. Place track plugs in the track where needed. Using the
fasteners provided, mount the track on the door per the template on
page 4.
1g Set Screw
Loosen the set screw in the end of the arm, open the door
approximately 30˚, pull the arm over the top of the door and
connect to the track roller. Tighten the set screw firmly.
1h Electric Checkout
Regulate the closer and perform an electrical checkout, as
instructed on page 2, before installing the closer cover.
1i Disengage the Swing Free Arm
To disengage the swing-free action of the arm, insert the locking
screw (stored in the tube portion of the arm) into the shaft end of
the arm, and tighten securely.
!
WaRNiNg
!
!
HaZaRDOUS VOLTagE
CaN SHOCK aND CaUSE
SEVERE iNJURY
Disconnect power before
making any electrical
connections or performing
maintenance.
HOW TO TELL HAND OF DOOR:
LEFT
HAND
DOOR
RIGHT
HAND
DOOR
MAXIMUM OPENING FORCE
=
33 ft-lbs
45 N-m
58 N
Customer Service
1-877-671-7011
www.allegion.com/us