LD 10A User manual - Active

Manual is about: STINGER SERIES ACTIVE & PASSIVE SYSTEMS

Page of 72

Download

Bookmark us

ACTIVE

SYSTEMS FEATURES:

POWER

The power LED lights up green when the device is turned on. The red Clip-LED starts blinking when the

amplifier reaches its clipping threshold. This should be avoided, to do so, reduce the master level (control

nr. 7 on the diagram) until the LED stops blinking.

VOLEX POWER PLUG

Special lockable mains socket (Volex Power Plug). Connect an IEC plug to this socket. The Fuse can be found

in the little compartment directly below this socket. To change fuses, pull out the little drawer. You will find

two fuses, one is in use and the other spare.

IMPORTANT NOTE: Only use suitable fuses. Never bridge the fuse contacts.

POWER SWITCH

Mains switch. Before switching on the power to the unit, all level controls should be set to minimum. Other

wise, microphones already connected to the system may cause undesired feedback.

SPEAKON OUTPUT

This additional speaker output (no impedance

can connect a passive speaker (e.g. the passive version of this speaker, the STINGER 12) to this output and

thus drive two speakers with a single amplifierunit.

ENGLISH

DEUTSCH

FRANCAIS

ESP

Añ

POLSKI