LD DAVE G3 SERIES User Manual - Limitation Of Liability

Manual is about: active 2.1 dsp based LD DAVE G3 SERIES

Page of 100

Download

Bookmark us

ENGLISH

DEUTSCH

FRANCAIS

ESP

AÑOL

POLSKI

ALIANO

MANUFACTURER´S DECLARATIONS:

LIMITATION OF LIABILITY

If your Adam Hall branded hardware product fails to work as warranted above, your sole and exclusive remedy

shall be repair or replacement. Adam Halls’ maximum liability under this limited warranty is expressly limited to

the lesser of the price you have paid for the product or the cost of repair or replacement of any components that

malfunction under conditions of normal use.

Adam Hall is not liable for any damages caused by the product or the failure of the product, including any lost

profits or savings or special, incidental, or consequential damages. Adam Hall is not liable for any claim made by

a third party or made by you for a third party.

This limitation of liability applies whether damages are sought, or claims are made, under this Limited Warranty

or as a tort claim (including negligence and strict product liability), a contract claim, or any other claim, and

cannot be rescinded or changed by anyone. This limitation of liability will be effective even if you have advised

Adam Hall or an authorized representative of Adam Hall of the possibility of any such damages, but not, however,

in the event of claims for damages in connection with personal injuries.

This manufacturer‘s warranty grants you specific rights; depending on jurisdiction (nation or state), you may be

be entitled to additional claims. You are advised to consult applicable state or national laws for a full determina-

tion of your rights.

REQUESTING

To request warranty service for the product, contact Adam Hall or the Adam Hall authorized reseller from which

you purchased the product.

EC DECLARATION OF CONFORMITY

The equipment marketed by Adam Hall complies (where applicable) with the essential requirements and other

relevant specifications of Directives 1999/5/EC (R&TTE), 2004/108/EC (EMC) und 2006/95/EC (LVD). Additional

information can be found at www.adamhall.com.