LD EB 102 User manual - Installation & Placement:
05
ENGLISH
DEUTSCH
FRANCAIS
INSTALLATION & PLACEMENT:
INTRODUCTION
The LDEB Series was designed in response to customer demands for high-quality multi-functional speakers. They are
equipped with selected components; feature a custom crossover and a very complete protection circuit.
MOUNTING OF THE
FLYWARE COMPONENTS
The LDEB122/152 are designed to allow the mounting of the Adam Hall 5720 flyware components. To mount these
components on the speaker first remove the flyware covers (“BMS Inside” and “Powered by Eminence” banners). With
the passing mounting screws you can install the Flyware rails (5720) in the pre-drilled cutouts. We also recommend
the use of back plates on the inner side of the speaker. In order to fit those back plates (like the 5730) on the speaker
box you must unscrew the front grid and build out the woofer.
Security advice: Adam Hall assumes no liability for the mounting of flyware components!
APPLICATION NOTICE FOR
SM707 ADjUSTABLE STANd RECEPTACLE
(LdEB122/152 PASSIvE ANd ACTIvE):
The built-in, patented SM707 adjustable speaker stand receptacle offers unparalleled possibilities for adjustment +/-
16° in 4° increments. To do this, simply lift the cabinet slightly on the speaker stand, causing the set angle to loosen,
and lower the cabinet on the stand again to cause it to engage at the desired angle (see drawing).
Centre of Rotation
+/- 16°
Lift cabinet
Attention! Please hold the
cabinet firmly!
Turn the cabinet into the
required angle.
Lower the cabinet.