LD LDEB102(A)G2 User Manual - Active Systems Features:
9
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
1
MIC IN
Balanced microphone input XLR/6.3 mm jack
(combo).
2
MIC GAIN
Gain control for microphone input.
3
LINE IN
Balanced line input XLR/6.3 mm jack (combo).
4
LINE GAIN
Gain control for line input.
5
LINE OUT
Balanced XLR output which allows you to connect
another active loudspeaker or mixer. Signal mix of
MIC IN and LINE IN.
6
VOLUME
Master volume control of the loudspeaker cabinet.
7
TREBLE
Turn left to decrease high frequencies. Turn right
to increase high frequencies.
8
BASS
Turn left to decrease low frequencies. Turn right to
increase low frequencies.
9
PROTECT LED
Lights up in case of unit overload/overheating.
Amplifier switches to mute automatically. The
unit will return to operation mode under normal
conditions after a few minutes.
ACTIVE SYSTEMS FEATURES:
10
LIMIT LED
Lights up when the loudspeaker is operated at it‘s
limit. Short-term blinking of the LED is not critical.
If the limiter LED lights up longer than a brief mo-
ment or permanently (= over-driving the system),
reduce the volume of the connected signal source.
Non-compliance will lead to unpleasant and
distorted sound and may cause malfunction of the
speaker system.
11
SIGNAL LED
Lights up when the unit receives an audio signal.
12
POWER LED
Lights up when power is switched on and mains
cable is connected correctly.
13
POWER SWITCH
Before switching power on, all level controls
should be set to minimum.
14
MAINS SOCKET (VOLEX POWER PLUG)
AC connection via IEC connector (220 - 240V AC).
A power cord with a lockable Volex connector is
supplied with this unit.
IMPORTANT: Replace fuse only by fuse
of same type and rating! If fuse blows
repeatedly please contact authorized service
center!
15
SPEAKER OUT
Powered Speakon compatible output which allows
you to connect a passive 8 Ohm speaker cabinet,
for example LDEB122G² or LDEB152G².