LD REVOLVER SERIES User Manual - Active Systems Features:
07
ENGLISH
DEUTSCH
FRANCAIS
1
MICROPHONE INPUT
Balanced XLR/Jack microphone input.
2
GAIN MICRO
Adjust the input sensitivity of the microphone input with this gain control. Please regard that microphones
needing phantom power (condenser microphones for example) will not work at these inputs since they do
not supply a phantom power.
3
LINE INPUTS
Balanced XLR/Jack line input (mono).
4
LINE INPUTS
Unbalanced stereo RCA line inputs.
5
GAIN LINE
Adjust the input sensitivity of the line input with this gain control.
6
LINE OUTPUTS
Balanced XLR output (mono). The two inputs (mic and line inputs) are mixed together according to the adjus-
ted levels and sent to this output. You can use this output to split the mixed inputs out to another active
speaker or amplifier.
Note: This output is split out before the master section (the controls 7, 8, and 10 on the Revolver 8”
and 10” models, and the controls 7, 8, 9 and 10 on the 12” and 15” models). This output is thus inde-
pendent from these controls.
7
VOLUME MASTER
This is the master volume control. You can adjust the overall volume of the amplifier – unit.
8
TREBLE
The treble control allows you to pad or boost high frequencies by -12dB respectively +12dB. (This function is
not available on the 8” and 10” models)
9
MID
The Mid control allows you to pad or boost mid frequencies by -12dB respectively +12dB.
10
BASS
The bass control allows you to pad or boost low frequencies by -12dB respectively +12dB.
11
POWER
The power LED lights up green when the device is turned on. The red Clip-LED starts blinking when the
amplifier reaches its clipping threshold. This should be avoided, to do so, reduce the master level (control
nr. 7 on the diagram) until the LED stops blinking.