LD ROADMAN 102 User Manual - Mulator
Before you install the Roadman 102 for the first time, the batteries should be charged for 12 hours.
When the battery charge status is low, the corresponding LED lights up red. During the charging process the LED
flashes green.
If you want to charge the batteries, you only need to plug the power cord of the appliance into a power socket.
The Roadman 102 is equipped with two batteries (12 V).
Recharge the battery fully at every opportunity. Never completely discharge a rechargeable lead battery or store
it in discharged or semi-charged condition. During extended periods of disuse and storage, the battery must be
recharged fully at regular intervals.
HOW TO REPLACE THE BATTERIES
1. Make sure that the device is turned off and not connected to the mains power supply.
2. Unscrew the bottom cover of the Roadman.
3. Remove the old batteries and insert the new ones. Be sure to pay attention to the correct polarity (red = + // black = - ).
4. Insert the new batteries and screw the cover back on.
5. Charge the new batteries for at least 12 hours.
BAtteRy
MulAtOR
:
16
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ES
pA
ño
L
po
LSKI
IT
ALIAN
o
THE BATTERY IS LOCATED IN THE BOTTOM OF
THE ROADMAN