Summary of Battle Fogger
Page 1
Battle fogger operations manual v30.10.02.
Page 2
Page 1 introduction page 2 warning page 3 technical specifications page 4 operating procedure page 5 remote handset operations page 5 remote handset led indicators page 5 remote and external control features page 6 battle fogger tube change procedure page 7 maintenance page 8 recommended fluids page...
Page 3: Introduction
The battle fogger is a microprocessor controlled, water base fog generating system. The microprocessor is responsible for the following control elements - monitoring the heat exchanger temperature. Driving the heater within the heat-exchanger. Driving the fluid pump unit, relating fluid flow to temp...
Page 4
M.S.D.S. Available by request or at www.Lemaitrefx.Com warning read these important safety instructions do not remove the outer case until power has been disconnected from the machine read these important safety instructions persons suffering from asthma or allergenic sensitivity may experience irri...
Page 5
Model: battle fogger type: water base fog generating system size: height: 9 1/2” 24 cm. Width: 9 3/8 23.8 cm. Length:22 1/2 57.1 cm. Net weight: 11.3 kg. 25 lbs. Weight with fluid 15.8 kg. 35 lbs. Power rating: 110 volt a.C. 50/60 hz 12 amps 240 volt a.C. 50/60 hz 6 amps included: full timer remote ...
Page 6: Operating Procedure
1) the battle fogger must only be connected to a grounded mains supply capable of sustaining at least 15 amps. The supply should be ‘clean’ and free of interference. 2) open a container of le maitre fog fluid , remove cap and break foil seal (if provided). Remove cap from battle fogger fluid resevoi...
Page 7
Note: remote handset operations the battle fogger remote handset was designed to indicate operation modes . These are as follows: slow flashing output: indicates unit is not ready to operate but still in heating mode, fog is not available at this point. Quick flashing output: indicates unit is ready...
Page 8: Caution !
1. Remove the six screws from the case. Four are under the lip at mid level and two are on top. Remove the bolt from the front of the fluid jug. Slide the upper cover forward and remove it from the machine. Lift the jug up and out of the way. 2. Remove the two screws from the front edge of the block...
Page 9
The casing of the battle fogger is steel with a powder paint coating. To clean simply wash with mild soap and warm water. With normal use we do not recommend flushing or cleaning the heat exchanger, with the use of genuine le maitre fluids. Using high quality le maitre fluid should result in a long ...
Page 10
This fluid has been our long standing blend. It is a clean, white, practically odourless fog. It is used for many applications where a cloud of fog is required with a medium hang time. This is a brand new blend. We have had many compliments on our fog fluid but many of our customers would like it to...
Page 11
Warranty: all warranty is one year parts and labour unless specified and is on manufac- turer defect only. Abuse or poor maintenance is not accepted. Le maitre fluids must always be used. Any trace of other fluids will automatically void all warranties. Accept no substitutions as there are no except...
Page 12
1. Ensure that operation of the machine is supervised by suitably trained and authorised personnel. 2. Do not modify the machine or use a machine which has been damaged in any way. 3. Allow sufficient air circulation around the machine at all times. 4. Protect the battle fogger from direct weather e...