Le Maitre G150 Operation Manual - page 7
5)
The Remote Display will now enter its standard phase. This indicates the Heating
power, the Flow rate setting, and the Ready status.
At this stage the flow rate may be adjusted freely between minimum and maximum
settings. (Upon entering a ready to operate phase the maximum allowable flow rate will
be automatically adjusted based on the energy available. )
6)
The Timer controls are of an auto-display option, and will display immediately upon
being adjusted, or if set to any position apart from the Interval being Off will display
approximately every 10 seconds.
The Interval control ( time between repeating fog issues ), allows the following
selection:
OFF -
No timer or time display
1-SH -
Single issues upon Fog activation
00:10'
-
Timer selection in 10 second steps
05:00'
-
to 5 Minutes, then 30 second steps
20:00'
-
to 20 Minutes.
The Duration control ( time of actual fog issue ) allows the following selection:
00.02'
-
Timer selection in 2 second steps
00.30'
-
to 30 Seconds then 30 second steps
08.00'
-
to 8 Minutes.
Note that when the automatic display of the timer settings occurs, the Interval time
will have a central colon (:) whereas the Duration time will have a central point (.) dis-
played.
7)
As the machine heats up to its operating temperature, if the flow setting has been
set to maximum, there will be a point when this will readjust to a much lower value. It is
at this point that the machine has reached its lowest ready point. A flashing H or G
will appear in the Ready Flash window, indicating that the machine is now ready at its
minimum level. The machine can in fact be operated at this point, or further time allowed
for maximum issue capabilities. If the machine is allowed further time, then the Flow rate
will be seen to increase in its allowable maximum setting until position 31 is reached.
5