Lea NetPlug User Manual - page 7
HomePlug Adapter Pairing and Net Management
lea-networks.com/us
Copyright 2013, LEA Networks LLC. All rights reserved. LEA Networks, NetPlug, NetSocket, SoftPlug, and LEA logos are
registered trademarks. Information is subject to change without notice. Rev.073013
7
Repairing a Broken Network
If changes are made to the network and everything stops working, or there is difficulty getting units paired, try the
following step by step procedure.
1.
Unplug all adapters from their wall positions.
2.
Use a power strip or multi-outlet extension cord to do the initial testing and pairing. Normally this is not
recommended, but the units will not have an issue connecting to each other when plugged into the same strip
or cord. Using a single cord will allow you to see the status lights and reset/pairing buttons easily. They will be
put back to their intended locations once pairing is completed.
3.
Plug two units into the active power strip or cord, making sure the buttons and lights are visible.
4.
Using a straightened paper clip, press the factory reset button for 1 second and release on each unit. The two
units should pair within 5 seconds, as indicated by the pairing light turning green. It is normal for the pairing light
to blink, this indicates they are communicating.
5.
If they do not pair, unplug the units for ~1 minute and re-plug them into the strip. Repeat pressing the factory
reset button on each for 1 second. If the pairing light never comes on then the units may be defective.
6.
If the units pair successfully, then unplug one and move it to its intended location. It’s ok to plug the adapter in
and connect it to whatever device it’s needed for. If only two adapters are in use, then unplug the second and
plug it in at its intended location and connect.
7.
If additional adapters are in use, leave the second unit plugged into the strip until all adapters are successfully
paired.
For additional adapters, plug them in one at a time into the strip. Press the reset button on only the new adapter for 1
second. As before, the two units should pair within 5 seconds, as indicated by the pairing light turning green. As the
additional adapters are paired, they can be unplugged and moved to their intended location.
Pairing Adapters using a Power Strip