Leader Light LL50 450 User Manual
USER MANUAL
LL PRO GRAPHIC PANEL
Leader Light s.r.o.
M.Gorkeho 33
SK-052 01 Spisska Nova Ves
Slovakia
www.leaderlight.eu
LL50 450
All dimensions are in millimeters
ENvIRONMENt
Do not throw away the appliance with the normal household waste at the end of its life,
but hand it in at an official collection point for recycling. By doing this, you help to preserve
the environment.
WARNING!!!
Carefully read before installing, powering or servicing.
Nothing to do if anything misunderstand! Installation can be done only
by a qualified professional in accordance with relevant local codes.
01 SAfEty INfORMAtION
01.1 Risk of eyes damage
Do not look directly into LED lamps.
Do not look into light beam from a distance of less than 40 cm (16 inches)!
-
-
01.2 Protection from electric shock
Shut down power before installation or maintenance.
Luminaries and recommended AC power supply must be installed by a qualified professional
in accordance with relevant local codes. Only acceptable source of AC power and frequency
that complies with local building and electrical codes to use.
Do not use or do not connect the products if the power cable, power plug or fixtures are any
way damaged, wet, or if they are overheating.
Do not modify, alter, or attempt to service the LeaderLight appliance. Doing so will void the
warranty.
Before removing or installing any cover or part of appliance disconnect it from AC power.
Appliance always connect to earth (eltech.).
-
-
-
-
-
-
01.3 fire prevention
Follow all safety consideration.
Thermostatic switches or fuses never to bypass.
Device never shield – minimum distance around fitting must be 100mm (4 in.).
LEDs never direct cover with filters or other materials.
Allowing max. ambient temperature is 40°C (104°F).
-
-
-
-
-
02 PROdUCt SPECIfICAtION
02.1 Technical Specification
LEd
INdICAtION
StAtUS
POWER (Red)
blinking – 2Hz
OK - inside fixture is everything correct
DATA (Green)
light off
NO DMX512 signal
DATA (Green)
blinking – 4Hz
OK- income correct DMX512 signal
DATA (Green)
fast blinking
NON correct digital signal
POWER (Red)
alternate blinking
Autotest function
DATA (Green)
Control LEds Indication
POWER
DATA
03 INStALLAtION
03.1 Unpacking
Unpack carefully.
This is electronic equipment and should be handled carefully.
Damaged delivered package or if are any mechanical parts broken – it must be claim
immediately by the transport company. Photo pictures as evidence are valuable for
future claim.
-
-
-
03.2 Physical installation
Loading capacity of bearing area has to be at least 10 times the weight of all device
clusters (luminaries, clamps, cables, ...).
Hairbreadth from combustible materials is 0,5m.
The LL PRO GRAPHIC PANEL is designed for use in a 600mm grid suspended
ceiling with T profile (Figure Nr. 1.1) or surface installation by LL HOLDER GRAPHIC
PANEL LL41 605 (Figure Nr. 1.2).
-
-
-
©MMX - Leader Light – All right reserved
02.2 data and Power connections
If you have any question please, contact support@leaderlight.sk
COMPLIMENtS ON yOUR PURCHASE!
Content:
01 SAfEty INfORMAtION
01.1 Risk of eyes damage
01.2 Protection from electric shock
01.3 Fire prevention
02 PROdUCt SPECIfICAtION
02.1 Technical Specification
02.2 Data and Power connections
02.3 Top panel
03 INStALLAtION
03.1 Unpacking
03.2 Physical installation
03.3 Connecting to AC power
03.4 Control data connecting
03.5 DMX channels
04 MAINtENANCE
Edition: A - 2010
DMX Out
XLR-5pin
DMX In
XLR-5pin
Power Out
PowerCon
Power In
PowerCon
Dip options
Rotating DIP address 000÷511
“100“ “10“ “1“
Control LEDs
POWER
DATA
MODE & ADDRESS
02.3 top panel
Lamp type:
144 x RGB TOP LED
*
Lifetime:
Long 100 000 hrs 60% degradation
Control data Input:
DMX512 In/Out with XLR 5pin
Input power:
max.60W
Power connection:
100-260V AC In/Out PowerCon
Net weight:
6kg
IP:
IP20
Ambient temp. (ta):
Maximum 40°C
Cooling:
Conventional
Materials and finish:
Housing: anodized aluminium black
Cover: plexiglass with special diffuse foile
Installation:
Surface, recesed or semi-recesed mounting
129,5
588
588
* TOP LED: R-Red, G-Green, B-Blue
following items are included:
- LL PRO GRAPHIC PANEL RGB
1 pc.
- PowerCon type “A“ + “B“
1 pc.
- User manual
1 pc.
Additional items needed:
- Data cables with XLR 5pin Female/Male
1 pc.
- Controller compatible with DMX
1 pc.
Surface mounting:
- LL HOLDER GRAPHIC PANEL SURFACE
1 pc.
- Screws and washers M12
4 pcs.