Leadtek WinFast TV Pro II User Manual - page 11
7
3.3 How to Operate this Machine
1. Power Switch
Press the [POWER] button of the control panel or the remote control to power up the TV Box.
2. Video Source Selection
Press the [Video] button of the control panel or the remote control to select the video sources between
TV, Composite Video, S-Video and PC.
The sequence of the source switch: TV (CATV/AIR) Æ Composite Video Æ S-Video Æ PC Æ TV
(CATV/AIR)
3. Channel Scan
Press the [Scan] button of the remote control to scan the TV channels.
4. Channel Switch and Volume Control
Press the [Ch+] or [Ch-] button of the control panel or the [CH▲] or [CH▼] button of the remote
control to switch the TV channels up or down.
Press the number keys and the [Enter] button of the remote control to select the specific channel.
Press the [Vol+] or [Vol-] button of the control panel or the [VOLf] OR [VOLe] button of the remote
control to adjust the volume.
5. Resolution Selection
Press the [RES] button of the remote control to switch between the different resolutions and the
corresponding refresh rates.
The sequence of the resolution switch:
640X480(60Hz) → 640X480(75Hz) → 800x600(60Hz) → 800x600 (75Hz) → 800x600(85Hz) →
1024x768(60Hz)→1024x768 (75Hz)→1024x768 (85Hz)→1280x1024(60Hz)→640x480(60Hz).
Note: The normal LCD monitors don’t support 85Hz refresh rate. If you switch to 85Hz but cannot get
the video image on your LCD monitor, please press the
[RES] once again and switch the refresh rate to the range covered
by the monitor. Then, you can get the video image shown on your LCD monitor.