1. DL manuals
  2. Leadway
  3. GPS
  4. LDW-TKV106
  5. User manual

Leadway LDW-TKV106 User manual

Manual is about: GPS Vehicle tracker. GPS+GSM+SMS/GPRS

Summary of LDW-TKV106

  • Page 1

    Gps vehicle tracker (ldw-tkv106) (gps+gsm+sms/gprs) user manual (1.4 version) please read this manual carefully before attempting installation and online activation. Pictures are for indication and illustration purposes only..

  • Page 3: 2.    Features

    2. Features ●gsm 850/900/1800/1900 quad band ●wide for voltage input range: 9-36v dc ●gps continuous positioning, gprs timing interval ●real-time tracking, history playback ●check location information via sms and gprs (tcp) ●tele-cutoff (petrol) function ●sos alarm ●acc ignition detection and vibrat...

  • Page 4

    Speed accuracy 0.1m/s time accuracy same as gps warm status 1s cold status 38s highest altitude 18000m max speed 515 m/s acceleration of gravity ﹤4g 2.1.2 others temperature -20---65℃ humidity 5%---95% voltage 10v—25v power 10v—25v average power ＜80ma led indicate the working condition and other con...

  • Page 5

    Led status meaning continuously in bright state working normally continuously in dark state low battery/power off 2.3 green led (gsm status indicator) led statue meaning flashing weak gsm signal/searching gsm signal continuously in bright state gsm conversation/start gprs continuously in dark state ...

  • Page 7: 4. Method Of Installation

    4. Method of installation 4.1. Preparation before installation 4.1.1 open the packing box to check whether the type of device is correct and whether the accessories are included, or else please contact your distributor. 4.1.2choose sim card: each device needs to insert a gsm sim card. Please refer t...

  • Page 8: 4.2 Installation

    4.1.4 installing sim card: the sim card slot is on the right side of device. Open the sim card silicon seal, then insert the sim card to the slot (do not insert the sim card backwards).When the sim card is ready you will hear a click. Or else please insert again and then replace the silicon seal. No...

  • Page 9: Note:

    Note: 4.2.1 to prevent theft of the device, it should be installed as covertly as possible. Covertly installation is suggested. 4.2.2 avoid placing the device close to higher power electrical devices, such as reversing radar, anti-theft device or other vehicle communication equipment; 4.2.3the devic...

  • Page 10: Notes of The Relay Wiring

    Line no. Specification color instruction 1.2 keypod orange/orange connect to sos button 3.4 mic-,mic+ black/red connect to microphone 5 tx green sending data(tx)backup 6 rx white receiving data (rx)backup 7 gnd black ground wire 8 motor yellow connect to relay control line 9 acc orange connect to ac...

  • Page 12

    5. Cautions of device wiring 5.1 power/acc/tele-cutoff (petrol/electricity) control line (4pin) 5.1.1 the standard voltage is 9v-36vdc.Please use the power line which provided by the manufacturer. The red line is the positive. The black line is the negative. The negative should earth alone or link i...

  • Page 13: 6．sms Command Format

    6．sms command format note: all the setup below can be only made by center number. Super user setup set the new center number and new password by sms through mobile phone. If the setup is successful, the module will send a reply with ‘config ok the main user and password is reset to 13689645010 (cent...

  • Page 14: Server Connection Setup

    Note: the default apn of this product is cmnet. Server connection setup format: #803# domain name or ip address # port number# this command is used to set gprs center server address, which could be fixed ip number. After the setup is successful, the module will send a reply with ‘config ok, the ip s...

  • Page 15: Vibration Alarm Setup

    Vibration alarm setup format: #zdbj # sensitivity (1-15 ） # alarm mode (0,1 )# sensitivity “1” is the most sensitive and of course “15” is the most insensitive. Alarm mode”0’ indicates vibration alarm is closed. Alarm mode”1” indicates the device will alarm you through calls or sms. Note: sms will b...

  • Page 16: Time Zone Setup

    The value of state is “0” and “1”,”1” means “open over-speed alarm”, “0” means “close over-speed alarm”. Example: #csbj#80#0# after sending command successfully, the tracker will return a message “config ok the warning speed is: 80 off”. Time zone setup format: #896# e or w # time zone # the value o...

  • Page 17: Device Setup Inquiry

    Numbers. (only this number can do voice monitor.) for example ： you want to set four stored numbers #711# 000000#13567892314#13892341600#13625678900#13625678901# the new numbers will replace the old numbers, and it will send confirmation to the sender if the password is right….Confg ok. Note: 136256...

  • Page 18: Sms Location Inquiry

    7. Sms & platform tracking sms location inquiry there is no need for center number to add the password to inquiry. Other numbers need to add the password to inquiry. 1） address tracking format: #666#password# for example you send #666#000000# to the tracker, you will get a reply sms as follow: sn: 8...

  • Page 19: Notes

    For details, please refer to our tracking system user manual. Notes 1. This non-waterproof equipment, please be sure to have waterproof bag. 2. This equipment has to work with gsm network. 3. Please ensure that there are enough expenses in sim card in order to avoid the inconvenience of using. 4. Th...