Lec 444443640 User Manual

Summary of 444443640

  • Page 1

    Refrigerator range user manual applicable models: 444443640 rc2dr 444443641 fc2dr 444443642 rc3dr 444443643 fc3dr 444443644 rc4dr 444443645 soc-1055mm 444443646 soc-1525mm 444443647 soc-2025mm 444443648 pc2dr 444443649 pc3dr 444443650 pct-1345mm 444443651 pct-1795mm 444443652 pct-2245mm 444443653 sa...

  • Page 3: Warranty

    Www.Lec-commercial.Co.Uk 1 warranty how to activate your warranty this lec platinum fridge comes with a 2 years parts and labour warranty from the date of purchase. Registering your product and activating your lec commercial warranty couldn’t be easier. Do not hesitate to call 0844 815 3755, and aft...

  • Page 4

    1. Introduction 2. Guarantee 3. Installation and assembly user manual zone serial number 1. Introduction we would like to thank you for your confidence in us for having purchased this refrigerated unit. This manual has been prepared in order to safeguard the security of the user and ensure the corre...

  • Page 5

    The user will be responsible for the following items: suitability of the premises to the requirements of the purchased unit. • electricity supply in accordance with the current standards and sufficient for the consumption • and safety of the unit. Material necessary to clean the unit. • water point ...

  • Page 6

    We recommend that the cleaning of the outside of the unit should be done on a daily basis and with a damp cloth. Once clean and dry, place the accessories in their proper places. Attention please do not use steel wire or nickel sponges to clean stainless steel or leave them lying on the surface as t...

  • Page 7

    1. Safety and inspection 2. General connections 3. Identification of the unit 4. Start-up 5. Use and limits 6. Recommendations 7. Precautions 8. Maintenance · gas condenser · evaporators · automatic evaporation tray · door seals 9. Operational tests · checks in the event of operational failure · noi...

  • Page 8

    1. Safety and inspection in order to inspect the unit before starting it up, the following checks should be taken into account: do not modify the specifications plate or instructions issued by the manufacturer. • do not remove or modify the safety elements. • do not touch the unit with wet or damp h...

  • Page 9

    3. Identification of the unit the unit, model and serial number are identified by means of the information displayed on the registration or on the data sheet that appears on all the products. 4. Start-up the unit, model and serial number are identified by means of the information displayed on the re...

  • Page 10

    5. Use and limits each unit is designed for a determined range of temperatures. • the temperature must be selected taking into account the following points: • type of product for refrigeration or conservation. • ambient temperature. • frequency with which the doors are opened. • although it is possi...

  • Page 11

    6. Recommendations you are recommended to wait until the chamber reaches its operational temperature before • introducing any product. In order to obtain better performance, avoid the introduction of hot foods as well as drinks that • are not in sealed packages. Protect foods and their odours by usi...

  • Page 12

    The manufacturer is exempt from all liability arising from non-compliance with the procedures con- tained in this manual. • gas condenser the incorrect maintenance and lack of cleaning of the gas condenser of the refrigerated unit can considerably reduce the performance of the unit as well as shorte...

  • Page 13

    The rubber door seals are designed to ensure the closure of the doors to the cold chambers and to guarantee the sealing of the doors against external elements. A magnetic strip is housed on the inside of the rubber seal, which adheres it to the frame of the unit. Over time granular particles can bec...

  • Page 14

    10. Constructive components the entire chamber where the foodstuffs are deposited is made from non-toxic material and appro- ved by the spanish food code. All the accessories and protectors comply with the same requirements, including all fastenings, nuts and bolts, which will be made of stainless o...

  • Page 15

    8 8 8 8.

  • Page 16: Sales Orders:

    Sales orders: email: sales@gdpa.Co.Uk tel: 0844 815 3755 (opt. 1) fax: 0844 248 4123 after sales: email: info@gdpa.Co.Uk tel: 0844 815 3755 (opt. 2) fax: 0844 248 4123 spare parts: email: info@gdpa.Co.Uk tel: 0844 815 3755 (opt. 3) fax: 0844 248 4123 marketing enquiries: email: marketing@gdpa.Co.Uk ...