Summary of L50263W
Page 1
Lec r50263w user manual.
Page 2: Lec Customer Care
Lec customer care please keep this handbook in a safe place. Please fill in the model number and serial number in the spaces provided below as they will assist us should you need to call. 0844 815 3737 when you dial this number you will hear a recorded message and be given a number of options. This ...
Page 3: Voltage:220V-240V
Specification of the appliance voltage:220v-240v frequency:50hz refrigerant:r600a rated current:0.6a lamp power: 10w insulation blowing agent:cyclopentane.
Page 4: Dairy Products
Description of the appliance 1 2 3 4 5 1. Freezer box – 2 star rating 2. Thermostat control, interior light 3. Interior glass shelf x 1 4. Salad crisper box with glass shelf 5. Door storage – specific areas for bottles & dairy products (picture shown for indicative purposes only, model supplied may ...
Page 5: Contents:
Contents: section 1. Installation section 2. Safety advice section 3. Operating the appliance section 4. Maintenance section 5. Warning.
Page 6: Section 1. Installation
Section 1. Installation important! This appliance must be left to stand in an upright position forat least 4 hours before being switched on for the first time. Remove all packaging and securing tape from the appliance. Wash the interior of the appliance with luke warm water containing a small amount...
Page 7: Section 2. Safety Advice
Please ensure that there is a small ‘air-gap’ between the condenser on the rear of the appliance and the rear wall. Do not place or store heavy items on the top of this appliance. Ensure that the appliance is positioned on a firm flat floor. This appliance must be level. Adjust the level by screwing...
Page 8
Manufacturer accepts no responsibility for incorrect installation and usage. If this appliance is to replace an old refrigerator with a lock, as a safety measure break or remove the lock and/or door before disposal. Your old appliances contain insulation gases and refrigerant that must be disposed o...
Page 9
Ensure that the electrical circuit is not overloaded as this could cause overheating. Do not twist or bend the cables, and keep them away from hot surfaces. Do not plug ın or unplug this appliance with wet hands. Following installation make sure that the power cable is not trapped underneath the app...
Page 10: 3.2. Temperature Control
Place the appliance close to the wall with a distance not exceeding 75mm 3.2. Temperature control the temperature selector knob is located on the right hand side of the inner cabinet (see description of the appliance on page 4). Please note that a larder fridge does not have an ice-box and will oper...
Page 11: 3.5. Energy Saving Advice
This appliance has a two star freezer-box and is suitable for the long-term storage of frozen food items. It can also be used for freezing and storing fresh food items. You should always follow the storage guidelines printed on each food producers packaging, however the following information is prov...
Page 12
Locate the appliance in a cool well-ventilated room and make sure that the air vents are clear. Try to avoid keeping the door open for a long time, warm air will enter the cabinet and may cause a build up of ice as well as affecting the energy consumption. Ensure there are no obstructions preventing...
Page 13: Section 4. Maintenance
Section 4. Maintenance before any maintenance or cleaning work is carried out, disconnect the appliance from the electricity supply. 4.1. Internal cleaning clean the interior and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. Do not use det...
Page 14: 4.6. Reversing The Door
But it may take some time to achieve the pre-set operating temperature. 4.4. When the appliance is not in use when the appliance is not in use for long periods, remove the contents, disconnect from the electricity supply and clean the appliance, leaving the door ajar until you wish to use the applia...
Page 15: Mains Beforehand.
When reversing the door, the appliance must not be connected to the mains. Remove the plug from the mains beforehand..
Page 16: Top Hinge Cover
Remove the plastic uppecover (1) remove the retaining screws and the top hinge (2) remove the plastic upper hinge cover (1) lift the door off the lower hinge (4). Remove the retaining screws and the lower hinge (4) remove the hinge pin and foot from the lower hinge (4), turn the hinge over and refit...
Page 17: Your Retailer.
There is no power to the appliance: check there is not a power cut check there is power to the electric socket/appliance check the fuse in the plug (must be 13 amp) the compressor runs continuously: is the door closed correctly? Have large quantities of food recently been added to the appliance? – i...
Page 18: Important Note:
Important note: this appliance is marked according to the european directive 2002/96/ec on waste electrical and electronic equipment (weee). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could othe...
Page 19
1. If the power cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 2. Children should be supervised to ensure that they do not play with the appliance. 3. "this appliance is not intended for use by persons(including...
Page 20
7. - warning: keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Warning: do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Warning: do not damage the refrigerant...